A comparative study of interface reconstruction algorithms in molten metal flow

来源 :China Foundry | 被引量 : 0次 | 上传用户:huangshuhui1983
下载到本地 , 更方便阅读
声明 : 本文档内容版权归属内容提供方 , 如果您对本文有版权争议 , 可与客服联系进行内容授权或下架
论文部分内容阅读
In the present research,two numerical schemes for improving the accuracy of the solution in the flow simulation of molten metal were applied.One method is the Piecewise Linear Interface Calculation(PLIC) method and the other is the Donor-Acceptor(D-A) method.To verify the module of the interface reconstruction algorithms,simple problems were tested.After these validations,the accuracy and efficiency of these two methods were compared by simulating various real products.On the numerical simulation of free surface flow,it is possible for the PLIC method to track very accurately the interface between phases.The PLIC method,however,has the weak point in that a lot of computational time is required,though it shows the more accurate interface reconstruction.The Donor-Acceptor method has enough effectiveness in the macro-observation of a mold filling sequence though it shows inferior accuracy.Therefore,for the problems that need the accurate solution,PLIC is more appropriate than D-A.More accuracy may cause less efficiency in numerical analysis.Which method between D-A method and PLIC method should be chosen depends on the product. In the present research, two numerical schemes for improving the accuracy of the solution in the flow simulation of molten metal were applied. One way is the Piecewise Linear Interface Calculation (PLIC) method and the other is the Donor-Acceptor (DA) method. To verify the module of the interface reconstruction algorithms, simple problems were tested. After accuracy and efficiency of these two methods were compared by simulating various real products. On the numerical simulation of free surface flow, it is possible for the PLIC method to track very accurately the interface between phases. PLIC method, however, has the weak point in that a lot of computational time is required, though it shows the more accurate interface reconstruction.The Donor-Acceptor method has enough effectiveness in the macro -observation of a mold filling sequence though it shows inferior accuracy. Beforefore, for the problems that need the accurate solution, PLIC is more appropriate than DA.More acc uracy may cause less efficiency in numerical analysis. Which method between D-A method and PLIC method should be chosen depends on the product.
其他文献
PPDB issues-four aspects of current management issues of foundry enterprises are discussed in this paper,including Production Management,Process Control,Duratio
The micro-porosity is usually present in the as-cast microstructure,which decreases the tensile strength and ductility and therefore limit the application of ca