Many years experience of the operation of high stress (＞72％ specified minimum yield strength,SMYS) gas pipelines and statistical analysis results of pipeline incidents showed that the operating pipelines at stress levels over 72％ SMYS have not presented problems in USA and Canada,and design factor does not control incidents or the safety of pipelines.Enhancing pipeline safety management level is most important for decreasing incident rate.The application history of higher design factors in the U.S and Canada was reviewed.And the effect of higher factors to the critical flaw size,puncture resistance,change of reliability with time,risk level and the arrest toughness requirements of pipeline were analyzed hem.The comparison of pipeline failure rates and risk levels between two design factors (0.72 and 0.8) has shown that a change in design factor from 0.72 to 0.8 would bring little effect on failure rates and risk levels.On the basis of the analysis result,the application feasibility of design factor of 0.8 in China was discussed and the related suggestions were proposed.When an operator wishes to apply design factor 0.8 to gas pipeline,the following process is recommended:stress level of line pipe hydro test should be up to 100％ SMYS,reliability and risk assessment at the design feasibility or conceptual stage should be conducted,Charpy impact energy should meet the need of pipeline crack arrest; and establish and execute risk based integrity management plan.The technology of pipeline steel metallurgy,line pipe fabrication and pipeline construction,and line pipe quality control level in China achieved tremendous progresses,and line pipe product standards and property indexes have come up to international advanced level.Furthermore,pipeline safety management has improved greatly in China.Consequently,the research for the feasibility of application of design factor of 0.8 in China has fundamental basis.