【摘 要】
：
In the course of studying on aerodynamic change and its effect on steering stability and controllability of an automobile in passing, because of multi interacti
【机 构】
：
State Key Laboratory of Advanced Design and Manufacture for Vehicle Body,Hunan Province Institute of
论文部分内容阅读
In the course of studying on aerodynamic change and its effect on steering stability and controllability of an automobile in passing, because of multi interaction streams, it is difficult to use traditional methods, such as wind tunnel test and road test. If the passing process of an automobile is divided into many time segments, so as to avoid the use of moving mesh which takes large calculation resource and CPU processing time in calculating, the segments are simulated with computational fluid dynamics (CFD) method, then the approximate computational results about external flow field will be obtained. On the basis of the idea, the change of external flow field of wagon-shaped car at the moment of passing is simulated through solving three-dimensional, steady and uncompressible N-S equations with finite volume method. Numerical simulation analysis of side force coefficient, stream lines, body surface pressure distribution of wagon-shaped car are presented and a preliminary discussion of aerodynamic characteristics of correlative situations is obtained. Finally, the Cs -x/l curve of side force coefficient(Cs) of car following relative distance (x/l) between cars is obtained. By comparison, the curve is coincident well with the experimental data,which shows creditability of numerical simulation methods presented.Key words: External flow field Passing Numerical simulation Side force coefficient
其他文献
The layered maximum a posteriori (L-MAP) algorithm has been proposed to detect signals under frequency selective fading multiple input multiple output (MIMO) ch
Large high-dimensional data have posed great challenges to existing algorithms for frequent itemsets mining.To solve the problem,a hybrid method,consisting of a
Unseen handset mismatch is the major source of performance degradation in speaker identifica-tion in telecommunication environments.To alleviate the problem,a m
Most change-point models assume that the response is continuous or cross sectional binary.However,in many public health problems,the data is longitudinal binary
The process of AIT-driven contact melting of the solid phase change material (PCM) around a horizontal elliptical cylinder heat source is analyzed. Aiming at th
高温高压下温度梯度法合成宝石级金刚石时,合成周期较长.单晶种合成效率低下,通过多晶种法可以直接有效地提高合成效率,因此文章对多晶种生长宝石级金刚石进行了研究,在高温
As one of the most important daily motor activities, human locomotion has been investigated intensively in recent decades. The locomotor functions and mechanics
The present paper develops an approach of relative orbit determination for satellite formation flight. Inter-satellite measurements by the onboard devices of th
A novel three-limbed robot was described and its motion planning method was discussed. After the introduction of the robot mechanical structure and the human-ro