【摘 要】
：
The effects of BaO addition on the phase composition, relative density and electric conductivity ofxCu/10NiO-NiFe2O4 (x=5, 10) cermets were studied, which were
【机 构】
：
State Key Laboratory of Powder Metallurgy
论文部分内容阅读
The effects of BaO addition on the phase composition, relative density and electric conductivity ofxCu/10NiO-NiFe2O4 (x=5, 10) cermets were studied, which were prepared with cold isostatic pressing-sintering process. The results show that the relative densities of 5Cu/10NiO-NiFe2O4 cermet doped with 1% BaO (mass fiaction) and 10Cu/10NiO-NiFe2O4 cermet doped with 1% BaO sintered at 1 473 K in nitrogen atmosphere, are increased by about 9.86% and 9.75% compared with the undoped BaO cermets, respectively. And the electric conductivities 22.79 S/cm of 5Cu/10NiO-NiFe2O4 cermets adding 1% BaO and 23.10 S/cm of 10Cu/10NiO-NiFe2O4 cermets adding 1% BaO are obtained, which are 2.21 times and 1.47 times of those of undoped samples,respectively. Moreover, the 10Cu/10NiO-NiFe2O4 cermets doped with 1% BaO have a maximum σ0 of 58.91 S/cm and electric conductivity of 23.10 S/cm at 1 233 K. Maybe low melting-point phases of BaFe2O4 and Ba2Fe2O5 have an excellent electric conductivity in xCu/10NiO-NiFe2O4 (x=5, 10) cermets at 1 233 K.
其他文献
TiO2 is a promising photocatalyst. However, the low photocatalytic efficiency calls for the modification of TiO2. Metal- and nonmetal-doping of TiO2 have been p
0引言化学肥料的推广对农业增产增收起到了关键作用，然而，多年来由于长期施用化学肥料，有机肥不足，土壤中各类养分比例失调，致使农田生态环境、土壤理化性状和土壤微生物区系受到
To investigate the influence of the solidification on the solder bump formation in the solder jet process, the volume of fluid (VOF) models of the solder drople
A series of the Pt-Sn/SBA-15 catalysts were prepared and their properties characterized by using X-ray powder diffraction(XRD),N2 adsorption-desorption,high res
Novel pyridine-containing macrocyclic compounds, such as 6,12,19,25-tetramethyl-7,11,20,24-dinitrilo-dibenzo[b,m]l,4,12,15-tetra-azacyclodoc osine (TMCD), were
The influence of crystallization on the corrosion behavior of Al86Ni6La6Cu2 amorphous alloy in 0.01 M NaCl solution was inves-tigated by electrochemical techniq
The adsorption properties of a novel gel-type weak acid resin (110-H) for Pb2+ were investigated using chemical methods and IR spectrometry. The optimal adsorpt
Using pressure swing adsorption(PSA)technology to purify carbon monoxide(CO)discharged from industria]gases is a high-efficiency and economicalmethod.In.this ar
As the aircraft and aerospace industry and the automobile industry are developed, the demand of reliable materials with high strength and high toughness is stea
Fluoropolymer and different kinds of silica particles were used for controlling surface chemistry and morphology,respectively. A superhydrophobic surface origin