论文部分内容阅读
从分析多波段红外烟幕性能和它在热像仪上的成像规则入手,阐述了应用热成像测试方法的基本思想、硬件配置与工作流程,详细介绍了热成像测试方法中有关烟幕面积计算的数学方法以及在本测试方法中使用的去除噪声和图像增强的图像处理过程,最后对整个热成像测试方法作了简单的分析.
红外烟幕面积的摄像测试方法
【摘 要】
：
从分析多波段红外烟幕性能和它在热像仪上的成像规则入手,阐述了应用热成像测试方法的基本思想、硬件配置与工作流程,详细介绍了热成像测试方法中有关烟幕面积计算的数学方法
【机 构】
：
军械工程学院光学与电子工程系,总参谋部第54研究所
【出 处】
：
军械工程学院学报
【发表日期】
：
2004年6期
【基金项目】
：
国防预研基金
其他文献
In this paper, we propose a design of a current controlled Quadrature Sinusoidal Oscillator. The proposed circuit employs three optimized Multi-output transline
1 二次短路熔痕的形成机理火灾现场中经常发现由于电流作用而熔化形成的短路熔痕.对于短路熔痕又可分为一次短路熔痕和二次短路熔痕.
Algorithmic Optimization of BDDs and Performance Evaluation for Multi-level Logic Circuits with Area
Binary Decision Diagrams (BDDs) can be graphically manipulated to reduce the number of nodes and hence the area. In this context, ordering of BDDs play a major
In this paper, two new electronically tunable filter configurations are proposed. The proposed filters operate current-mode (CM), voltage-mode (VM), transimpeda
This paper presents a new current-mode single input multi output (SIMO) type biquad employing one voltage differencing transconductance amplifier (VDTA), two gr
This paper proposes an nth order (where n = 2,3, ,n) voltage mode active-C filter using n number of current controlled current conveyors (CCCIIs) and n number o
The paper deals with a lossy transmission line terminated at both ends by non-linear RCL elements. The mixed problem for the hyperbolic system, describing the t
A new design technique employing CMOS Current Feedback Operational Amplifier (CFOA) is presented. This design approach applies CFA OTA as input stage cascaded w
“一方有难、八方支援”是中华民族的传统美德，也是工商银行社会责任感的体现。2008年5月12目，四川省汶川县发生8级强烈地震后，工行海南省分行党委及时对抗震救灾工作进行了安排
Behavioral Modeling and Simulation of Cascade Multibit ΣΔ Modulator for Multistandard Radio Receiver
In this paper, a cascade Sigma-Delta (ΣΔ) Analog to Digital Converter (ADC) for multistandard radio receiver was presented. This converter is supposed to be a