论文部分内容阅读
针对曲轴连杆颈内铣加工,介绍应用用户宏程序功能开发基于曲轴几何形状尺寸、刀具信息、切削工艺参数、刀具补偿等数据编程的加工循环。
曲轴连杆颈内铣加工宏程序的开发
【摘 要】
：
针对曲轴连杆颈内铣加工,介绍应用用户宏程序功能开发基于曲轴几何形状尺寸、刀具信息、切削工艺参数、刀具补偿等数据编程的加工循环。
【机 构】
：
湖北汽车工业学院,东风（十堰）精密设备有限公司,东风轻型发动机有限公司
【出 处】
：
制造技术与机床
【发表日期】
：
2011年5期
其他文献
Background: Stapled hemorrhoidectomy, popularly known as Longo technique is in use for the treatment of hemorrhoids since its first description to surgical frat
The vasoactive effects of oxidative stress induced by hydrogen peroxide (H2O2) on human umbilical artery strips as well as the possible mechanisms involved are
Purpose: The use of port catheters is well accepted in the management of patients with malignancy. In this study, we compare the technical success and the compl
提出了一种基于模糊自整定PID的同步控制方案。设计模糊自整定PID控制器应用在龙门移动式镗铣床中双电动机驱动的轴间反馈回路。以抑制由不同步引起的不平衡扭矩。并且由IP控
Acute Type I aortic dissections are fast progressing highly mortal vascular emergencies if management delays. In this particular paper we report a case with a T
Introduction: Rectal prolapse is a relatively common, usually self-limiting illness in children. Peak incidence is between 1 and 3 years. The intervention is re
In this paper, a presented definition of type-2 fuzzy sets and type-2 fuzzy set operation on it was given. The aim of this work was to introduce the concept of
In this work empirical models describing sampling error (Δ) are reported based upon analytical findings elicited from 3 common probability density function
In this paper, we are concerned with the Riesz means of Dirichlet eigenvalues for the sub-Laplace operator on the Engel group and deriver different inequalities