A novel four light ray path test method for measuring residual reflectance has been presented. Residual reflectance spatial distribution at a cladding interface was measured using the technique. Residual reflectance could be on the order of 10?5
【机 构】
：
ShanghaiInstituteofOpticsandFineMechanics,ChineseAcademyofSciences,Shanghai201800,China
论文部分内容阅读
A novel four light ray path test method for measuring residual reflectance has been presented. Residual reflectance spatial distribution at a cladding interface was measured using the technique. Residual reflectance could be on the order of 10?5 by matching the refractive index of Nd:glass, polymer, and cladding glass and eliminating defects in the adhesive layer. Residual reflection spatial distribution appears to be similar to Newton rings due to the edge surface flatness. The relationship between the residual reflectance and the edge surface flatness was discussed, and the results revealed that the edge surface flatness is very important during the cladding process.
其他文献
In this letter, a modified grouped bit-flipping decoding algorithm for low-density parity-check (LDPC) coded pulse position modulation (PPM) signals is proposed. The improvement in performance is observed by Monte Carlo simulations. The coding gain is mor
激光，由于解决了通常的精密和强度这一对矛盾的性质已使原子物理学从死亡之中复苏:看来，每个星期都带来大量新的和令人兴奋的发现。最关心的问题之一是扩展激光器运转的波长范围——特别是在短波端。目前，激光器已发展至能在紫外区深部运转。
A diode-pumped passively Q-switched Nd:YAG/KLu(WO4)2 (KLW) Raman laser is presented for the first time. As high as 1.89 W average output power is obtained at the pump power of 15.7 W with the pulse repetition frequency (PRF) of 27.2
介绍了液相生物芯片检测技术的进展,给出了一种能对液相生物芯片进行快速、准确、高灵敏度分析的检测技术。该技术采用数字图像采集技术获取二维检测区域的微球探针荧光信号,提高了检测速度。微流场是液相芯片的检测场所,研究了微流场系统的设计和流速控制方法。
A new optical microscopy technique, termed high spatial and temporal resolution synthetic aperture phase microscopy (HISTR-SAPM), is proposed to improve the lateral resolution of wide-field coherent imaging. Under plane wave illumination, the resolution i
近代光学物理最重要的成就之一是1966年由Sorokin和Lankard以及ScMfer等各自独立发明的染料激光器。有机染料激光器的出现，提供了一种波长跨越很宽范围连续可调的相干辐射源。在某些实验，如多光子吸收和非线性光学实验中，往往同时需要两个或两个以上能独立调节的髙功率脉冲激光波长。然而，由于激光脉冲的典型宽度为5 ns,因此，任何一个的频率抖动都将使两个独立的激光器难以同步。如果用单泵激励双波长染料激光器就可保证输出在时间上的一致性，从而避免了上述困难。迄今已发展了若干不同类型的双波长染料激光器。1
We study an electronic compensator (EC) as a receiver for a 100-Gb/s polarization division multiplexing coherent optical orthogonal frequency division multiplexing (PDM-CO-OFDM) system without optical dispersion compensation. EC, including electrical disp
本文报道了AgGaS2晶体Ⅱ类非共线相位匹配Q开关Nd:YAG激光泵浦CO2激光参量上转换研究结果,用迭代法计算了相位失配因子ΔK=0时的最佳非共线夹角.当泵浦功率密度为6MW/cm2和晶体长度为4.7mm时,功率转换效率达16.1%,并且首次采用硅雪崩光电二极管接收和频信号.
工作在超辐射模式下的集体区自由电子激光器的增益特性研究可以通过改变互作用区长度及泵浦强度来进行。我们利用偏转磁场可以获得任意的相互作用区长度。实验结果证明,工作在集体区的自由电子激光的辐射增益随泵浦磁场近似呈1.7次方关系,实验测得的增益系数范围为0.4dB/cm到1.38dB/cm。
多参数联合优化是光刻分辨率增强技术的发展方向。提出了一种以光刻胶三维形貌差异为评价目标的光刻多参数联合优化方法。以多个深度位置的光刻胶图形误差为目标函数,对光源、掩模、投影物镜波前、离焦量和曝光剂量进行联合优化,提高了光刻胶图形三维形貌的质量。为获得较高的优化效率,采用自适应差分进化算法实现光源和掩模的优化,并针对其他参数的特点,采用不同优化方法进行优化。对密集线、含有交叉门的复杂掩模图形和静态随机存储器中的典型图形进行了仿真验证,可用焦深的最大值分别达到237 nm、115 nm 和144.8 nm,曝