LJ113交叉槽式万向节 ,滑移端在转动内圈形成轴间角过程中出现滞点现象。分析其原因是沟道和平面A不垂直 ,形成一个角度 ,且这个角度不固定。通过维修和调整电主轴 ,最终使滑移端在转动过程中消除了滞点现象。附图 1幅 ,表 1个。 LJ113 cross groove universal joints, sliding end of the formation of the axis of rotation in the shaft between the formation of stagnation point phenomenon. Analysis of the reason is that the channel and the plane A is not vertical, forming an angle, and this angle is not fixed. By repairing and adjusting the spindle, the dead end is eventually eliminated during rotation. Figure 1 Figure, Table 1.