Localized corrosion of LY12CZ under stress in chloride media

来源 :中国有色金属学会会刊(英文版) | 被引量 : 0次 | 上传用户:yingyingpps
下载到本地 , 更方便阅读
声明 : 本文档内容版权归属内容提供方 , 如果您对本文有版权争议 , 可与客服联系进行内容授权或下架
论文部分内容阅读
Electrochemical methods were applied to investigate the corrosion behaviour of LY12CZ under applied stress in 3% sodium chloride aqueous solution. The experimental results indicate that LY12CZ shows two breakdown potentials on its polarization curve: one is related to the dissolution of the intermetallic particles and the other is related to the cracking of oxidation film and the dissolution of the matrix. When the stress is applied, it varies both breakdown potentials and makes the intermetallic particles and matrix dissolute at lower potentials. The relationship between the variation of the two breakdown potentials and applied stress was summarized. At the same time the influence of stress on the pitting and intergranular corrosion sensitivity of LY12CZ was also investigated. From the results it can be concluded that the stress can significantly affect the localized corrosion behaviour of LY12CZ in 3% NaCl solution.
其他文献
316L stainless steel samples,as a widespread used material,were irradiated with HIPIB at the beam parameters of ion energy 300 keV,current density 100,200 and 3
The existence of yttrium in Ti-23Al-25Nb alloy and its influence on the microstructure after heat treatment of Ti-23Al-25Nb alloy were investigated using therma
Dipolar relaxation and dielectric/piezoelectric resonance in a (001)-cut Pb(Zn1/3Nb2/3)0.9Ti0.1O3 (PZNT10%) single crystal before and after electric (E)-field p
Three different coatings, Cr, SiO2/Cr and HfO2/SiO2 were deposited by electron beam physical vapor deposition (EB-PVD). Relevant composition and mechanical prop
A novel Al-based composite material (Al63Cu25Fe12)p/A356 was prepared by spray co-deposition. It is revealed that the reinforcement of Al63Cu25Fe12 quasicrystal
The corrosion behavior of a CuCrNiAl alloy in HCl solutions was studied by means of metallograph, XRD, SEM/EDX and TEM methods. The results show that in low con
Current—voltage (I—V) and capacitance-voltage (C—V) characteristics of Au/p-CZT contacts with different surface treatments on cadmium zinc telluride (CZT) wa
Compositional graded BaxSr1-xTiO3 (x=0.6,0.7,0.8,0.9,1.0) (BST) thin films (less than 400 nm) were fabricated on Si and Pt/Ti/SiO2/Si substrates by sol-gel tech
Low temperature sintering NiCuZn ferrite was employed at most cases due to its co-firability with Ag (below 960 ℃). The NiCuZn ferrite sintered body with high-
The carbon nanotube (CNT) growth of iron oxide-deposited trench-patterns and the locally-ordered CNT arrays on silicon substrate were achieved by simple thermal