【摘 要】
：
New method for handling roof of the base successive mining is proposed, which is induction caving in the roof. The key is that it is made certain to the station
【机 构】
：
School of Resources and Safety Engineering
论文部分内容阅读
New method for handling roof of the base successive mining is proposed, which is induction caving in the roof. The key is that it is made certain to the station of the space-time in the induction caving roof, as the stress is released with the mining process. And applying the catastrophe theory, the influencing factors of induction caving roof are studied in the emptied areas, such as the mechanical property of the surrounding rock, the area of the gob,the scope and dimension of tensile stress. The results show that the key factor is the area of the gob to the method of the induction caving roof. Then according to the geology and the ore characteristic, the three dimension FEM mechanical model is built in Tongkeng Mine, the laws of the tensile stress are analyzed to the space and the time in the roof with the mining, then it is rational design to the mine step and time of the handing the roof.
其他文献
An Al2O3f/Al-4.5Cu composite was made by squeeze casting. The solute segregation in the composite at different cooling rates was studied. The results indicate t
The foreign experimental and FEM research of steel moment-resisting connection reinforced with steel plates are introduced. The effect of weld on the connection
The dry friction and wear characteristics of three kinds of friction couples under different loads, MoSi2/45 tempered steel, MoSi2/45 quenched steel, and MoSi2/
Nano-SiO2 particles strengthened Ni-based composite coating was designed and prepared on steel substrate. The structures and nanoparticle content of the nano-Si
A 20 vol.% SiCp/Al composite was fabricated by squeeze casting, of which a new process for fabricating the preform was used by blending Al powder and SiC partic
The life cycle index of remanufactured engines was assessed by using the method of life cycle assessment (LCA). A remanufactured engine of a certain domestic br
Under the condition of equal flow, the maximum and minimum theoretical values of gap size were studied and an estimation equation was established for the clad e
The deformation behavior and the contact area of conductive particles in anisotropically conductive adhesives (ACA) were investigated by finite element method (
The fuzzy C-means clustering algorithm(FCM) to the fuzzy kernel C-means clustering algorithm(FKCM) to effectively perform cluster analysis on the diversiform st
A parametric model of cutting temperature generated in end milling process is developed according to the thermal mechanism of end milling as an intermittent ope