【摘 要】
：
17-4PH stainless steel powders were prepared using a supersonic nozzle in a close-coupled gas atomization system.The characteristics of powder particles were ca
【基金项目】
：
the National High-Tech Research and Development Program of China;国家自然科学基金
论文部分内容阅读
17-4PH stainless steel powders were prepared using a supersonic nozzle in a close-coupled gas atomization system.The characteristics of powder particles were carried out by means of a laser particle size analyzer,scanning electron microscopy (SEM),and the X-ray diffraction (XRD) technique.The results show that the mass median particle diameter is about 19.15 μm.Three main types of surface microstructures are observed in the powders:well-developed dendrite,cellular,and cellular dendrite structure.The XRD measurements show that,as the particle size decreases,the amount of fcc phase gradually decreases and that of bcc phase increases.The cooling rate is inversely related to the particle size,i.e.,it decreases with an increase in particle size.
其他文献
目的：探讨八年制医学生骨科见习课中基于数字骨科技术的教学创新实践效果。方法以2015学年进入骨科临床见习的40名八年制医学生为教学对象，将其平均分为两组。一组采用数字骨科
2011年重庆市住院医师规范化培训工作（简称住培）全面启动，重庆医科大学附属儿童医院以提高岗位胜任能力为导向，采用“戴明环”式管理，利用形成性评价的各类考核量表进行学员过程考
We present a new approach based on honey-bee mating optimization to estimate the state variables in distribution networks including distributed generators. The
This paper proposes an analysis and a direct power control (DPC) design of a wind turbine driven doubly-fed in-duction generator (DFIG) under unbalanced network
A multivariable regression (MVR) approach is proposed to identify the real power transfer between generators and loads.Based on solved load flow results,it firs
This research develops a novel feasible approach to fabricate Fe-Pt bimetallic nanoparticles (NPs).The overarching goals are to provide guidelines for the desi
This paper first introduces a way to improve interactivity with high polygon count virtual objects through the "mixed" use of image-based representation within one object. That is, both 3D polygonal a
Chip multiprocessors (CMPs) allow thread level parallelism,thus increasing performance.However,this comes with the cost of temperature problem.CMPs require more
A rational approximation method of the fractional-order derivative and integral operators is proposed.The turning frequency points are fixed in each frequency i
A numerical procedure for analyzing the temperature distribution in a hollow axisymmetric cylinder,made of functionally gradient material (FGM),was investigated