论文部分内容阅读
该文从挂篮荷载计算、施工流程、支座及临时固结施工、挂篮安装及试验、合拢段施工、模板制作安装、钢筋安装、混凝土的浇筑及养生、测量监控等方面人手,介绍了S226海滨大桥主桥连续预应力混凝土变截面箱梁2#～7#块、8#、8
Effects of Processing Variables on Microstructure and Yield Ratio of High Strength Constructional St
【摘 要】
：
该文从挂篮荷载计算、施工流程、支座及临时固结施工、挂篮安装及试验、合拢段施工、模板制作安装、钢筋安装、混凝土的浇筑及养生、测量监控等方面人手,介绍了S226海滨大桥
【机 构】
：
State Key Laboratory of Rolling and Automation,Northeastern University,Shenyang 110819,Liaoning,Chin
【出 处】
：
城市道桥与防洪
【发表日期】
：
2016年8期
其他文献
Mathematical models for burden descending process have been applied to obtain whole burden structures in blast furnace,whereas the accuracy of those burden desc
An Innovative Approach to Separate Iron Oxide Concentrate from High-sulfur and Low-grade Pyrite Cind
该文从挂篮荷载计算、施工流程、支座及临时固结施工、挂篮安装及试验、合拢段施工、模板制作安装、钢筋安装、混凝土的浇筑及养生、测量监控等方面人手,介绍了S226海滨大桥
To shorten the time required for the pickling process and to enhance the quality of ferritic stainless steel plates,the effects of oxidants including hydrogen p
Numerical Simulation and Experimental Study of an Ultrasonic Waveguide for Ultrasonic Casting of 35C
To achieve ultrasonic casting of 35 CrMo steel,the waveguide unit for introducing ultrasound into liquid steel was studied numerically and experimentally.The st
The knowledge of transient temperature of the ladle wall is a key factor in optimizing energy consumption in steelmaking process.The transient temperature needs
To develop a high-efficiency desulfurizer for the production of pipeline steel with the LD-RH-CC process,the desulfurization efficiency and mechanism of CaO-sat
Obtaining small carbides is crucial but difficult for high-speed steels.A new approach for refining carbide dimensions in M42 super hard high-speed steel by inc
Cable-type welding wire(CWW)CO_2 welding is an innovative process arc welding with high quality,high efficiency and energy saving,in which CWW is used as consum
Total 72 lapped specimens including six different kinds of CR340 steel structures were prepared to study the influence of the spot welding technology on their f
One assumption underlying the conventional dilatometric analysis based on the lever rule is that the volume of the specimen changes isotropically during phase t