Ultrasonic Pulse Signal Resonance Features in Layered CFRP Within Voids

来源 :武汉理工大学学报(材料科学版)(英文版) | 被引量 : 0次 | 上传用户:fxlilac
下载到本地 , 更方便阅读
声明 : 本文档内容版权归属内容提供方 , 如果您对本文有版权争议 , 可与客服联系进行内容授权或下架
论文部分内容阅读
The ultrasonic pulse signal resonance features in layered carbon fiber reinforced plastic (CFRP) within voids were researched.The frequency domain model of acoustic wave propagation in multilayered medium was established.Then the reflection coefficient of multilayered CFRP within voids was numerically calculated.The results are as follows.When the CFRP laminate is tested by ultrasonic whose center frequency is close to the CFRP inherent resonant frequency,the ultrasonic may generate resonance phenomenon in CFRP.If CFRP contains evenly distributed voids,the frequency of resonant signal and its amplitude all decrease with the increase of porosity.For the thick section CFRP within local concentrated voids,the local concentrated voids near testing surface will cause signal frequency reduction and the decrease of its amplitude.But the voids which exist in layers far away from testing surface almost have no influence on signal resonance.The ultrasonic pulse echo testing was conducted for thick section CFRP specimen.The analysis results of testing signals were in accordance with the results of the numerical calculation,showing that the reflection coefficient frequency response model can effectively explain the ultrasonic resonance phenomenon in layered CFRP within voids.
其他文献
The effects of ultrasonic vibration temperature on the microstructure of semisolid Sn-52Bi alloy and mechanical properties were investigated. The results show that the microstructure and mechanical properties are improved obviously after the ultrasonic tr
C/C composites are the emerging materials of choice for aero-engine hot-end components that will bear impact loading in thermal-oxidizing environments. For the components run for extended periods, the safe operation of components depends on how to evaluat
Cu-Ni core-shell nanowires, with an inner Cu core diameter of about 60 nm and varying Ni shell thicknesses (10, 30, 50, 60, and 80 nm), were successfully fabricated in porous polycarbonate (PC) ion-track templates by a two-step etching and electrodepositi
A new low-cost corrosion-resistant rebar (HRB400R) was designed and fabricated by chromium micro-alloying. The effects of Cr on the passivation and corrosion behavior of this rebar in the simulated concrete pore solutions were studied systematically, and
During quenching, the residual stresses are affected by the crystallographic orientation of martensite, because the nonuniform thermal stresses affect the crystallographic orientation of the lath-shaped martensite and induce the anisotropic expansion. To
The maximum principal stress, von Mises equivalent stress, equivalent creep strain, stress triaxiality in dissimilar metal welded joints between austenitic (HR3C) and martensitic heat-resistant steel (T91) are simulated by FEM at 873 K and under inner pre
The preforms with high SiC volume fraction (>50%) were successfully fabricated by two bonding methods. Moreover, the dimensional change, compressive strength, and microstructure of SiC preforms were investigated, and the bonding mechanism among SiC partic