提出以下的测量工艺系统或机床(特别是车床)刚度 的方法。 把千分表夹紧在刀架上(见图),用它来测量在切削过程中车刀的压出量(ОТЖИМ)。如吃刀深度超过2公厘,应该采用分度为0.01公厘的千分表。当吃刀深度很小时,则用分度为0.002公厘的千分表。 首先把毛坯表面车光,使其相肖 The following method of measuring the stiffness of a process system or a machine tool, particularly a lathe, is proposed. Clamp the indicator on the tool holder (see picture) and use it to measure the amount of turning out of the tool during the cutting process (ОТЖИМ). Such as eating knife depth of more than 2 mm, should be used to index 0.01 mm dial indicator. When the depth of the knife is very small, then indexing 0.002 mm dial indicator. First of all rough surface car light, make it similar