原锻模进出炉淬火采用人压杠杆,借用炉内钢球耐热导轨以及天车吊的方法,淬火几百斤重的模块,劳动强度大,又不安全,车间提出要搞一个机械化淬火小车,经过厂内外协作和各方努力,只用了半年时间就设计制造成功。小车在炉前轨道上行驶,小车上装有带导向的两根长杆,可同时伸入炉内,并靠液压油缸将长杆稍稍抬起,以便取放炉内模块;长杆又可在小车上部转位±180°,与原机械化淬火 The original forging die into and out of the furnace quenching pressure by the use of people, borrow the furnace heat ball rail and crane hanging method, quenching a few hundred pounds of heavy module, labor-intensive, but also unsafe, the workshop proposed to engage in a mechanized quenching car After the cooperation inside and outside the factory and the efforts of all parties, it took only half a year to design and manufacture successfully. Car in the furnace before the track, the car is equipped with two guide rod with the rod can be extended into the furnace at the same time, and hydraulic rod will lift the rod slightly in order to take the furnace module; long pole and the car The upper index ± 180 °, with the original mechanized quenching