【摘 要】
：
SiOx (x=0--2) films were deposited on BK-7 substrates by a low frequency reactive magnetron sputtering system with the oxygen flow rate (OFR) changing from 0 to 30 sccm. The samples were characterized by atomic force microscopy, spectrophotometer, and X-r
【机 构】
：
HefeiNationalLaboratoryforPhysicalSciencesatMicroscale,andUSTC-ShincronJointLab,UniversityofSciencea
【出 处】
：
ChineseOpticsLetters
论文部分内容阅读
SiOx (x=0--2) films were deposited on BK-7 substrates by a low frequency reactive magnetron sputtering system with the oxygen flow rate (OFR) changing from 0 to 30 sccm. The samples were characterized by atomic force microscopy, spectrophotometer, and X-ray photoelectron spectroscopy. The extinction coefficient and refractive index decrease, while the optical transmittance increases with the increase of OFR from 0 to 17 sccm. The root mean square surface roughness has a maximum at 10 sccm OFR. The highest deposition rate is at 15 sccm OFR. Our results show that the films deposited at 20 sccm OFR are stoichiometric silica with relatively high deposition rate, low extinction coefficient, and low surface roughness. Therefore, a precise control of OFR is very important to obtain high quality films for optical applications.
其他文献
最近，一些科技工作人员报告了用激光观测上层大气的实验结果，他们探测了流星尘及气溶胶层。用激光代替普通的无线电波的优点是能荻得较高的能量密庋及中性粒于的反射。由此看来，激光对于观测中性流星尘密庋、真正的上层大气流、夜辉光及其与各种气象现象的关系是很有利的。
A novel design of multimode light power splitter is proposed and fabricated by using secondary asymmetric Y branches. An almost equally divided output among output terminals is obtained experimentally. Maskless laser direct writing technique is applied in
We apply graph matching method to detect infrared small moving targets using image sequences. Candidates (interest points) detected in the first frame form one graph and the same candidates in the last frame form another one. The real moving targets are e
为了研制出高质量光学表面的离轴非球面碳化硅反射镜，提出一套包括铣磨成型、研磨、粗抛光、表面改性以及精密抛光等工序的完备的离轴非球面碳化硅反射镜加工工艺规范。采用Ultrasonic 100-5数控加工机床直接将Φ600 mm碳化硅反射镜铣磨成离轴非球面，铣磨后反射镜面形精度的峰谷(PV)值为17.17 μm。利用计算机控制光学表面成型（CCOS）技术对离轴非球面碳化硅反射镜进行研磨和粗抛光，使其面形精度的均方根(RMS)值达到0.102λ（λ=0.6328 μm）。采用离子束辅助沉积(IBAD)表面改性技
The perturbation theory of matrices is applied to ray transfer matrices (RTMs) to describe an optical component with aberration. A quantitative description of the perturbation extent corresponding to aberration strength is provided using condition numbers
An ultraviolet (UV) Raman lidar system at 354.7 nm has been developed for accurately measuring the aerosol extinction profiles. A spectroscopic filter combining a high-spectral-resolution grating with two narrowband mirrors is used to separate the vibrati
The combination of lens and pinhole limits the enhancement of the laser output power in the high-power laser system. Low-pass spatial filter without focusing can surmount the drawbacks of the pinhole filters. The low-pass spatial filters based on multilay
在许多激光应用中，要求把激光聚焦到衍射极限。对稳定腔激光器而言，这意味着激光器以TEM00模或横模工作。由于环形光边缘有衍射环，这问题本质上是较复杂的。
相位敏感光时域反射计(φ-OTDR)可以有效地检测光纤的振动信息,但受传感光纤长度的限制,可检测的振动频率范围一般在几百赫兹到几千赫兹之间。为了提高振动检测范围,组建了基于外差相干检测的φ-OTDR系统,采用I/Q解调方法获得传感光纤散射光信号的相位信息,对此相位信息在空间域与时域上相继进行差分相位解调,从而实现对光纤中高频振动信号的分布式检测。理论上分析了高频振动检测方案的可行性,并在实验中有效解调出了频率为500 kHz的振动信号,传感距离达到了23 km。