论文部分内容阅读
金刚石在工厂中的用途很大,像修整砂轮就经常要用到它。由于它的价格很贵,而体积又小,所以在使用时要特别小心,以免浪费。下面将我们焊接和使用金刚石的一些经验介绍给大家参考。一、金刚石的焊接方法 1)埋入焊法:先准备一个钢棒,在钢棒的一端钻孔,再把金刚石放进这孔内,用黄铜焊好就行了(如图1)。这种焊法的缺点,是金刚石容易松动及丢掉。2)铆进焊接:铆进焊接和埋入焊接基本上相同,只是金刚石放入孔内后,要先用手锤将钢棒顶端周围均匀地铆紧,然后用铜焊焊牢。钢棒小孔部可锯两
The use of diamond in the factory is great and it is often used as a dressing wheel. Due to its high price and small size, extra care should be taken when using it to avoid waste. Below we will introduce some of the experience of welding and using diamonds for your reference. First, the diamond welding method 1) buried welding method: first prepare a steel rod, drill in one end of the steel rod, and then put the diamond into the hole, with brass welding good on the line (Figure 1). The disadvantage of this welding method is that diamond is easily loosened and discarded. 2) riveting into the welding: riveting into the welding and buried welding is basically the same, but the diamond into the hole, the first hand hammer to riveting evenly around the top of the steel rod, and then brazing with brazing. Small holes can be sawed two steel bars