带压修井作业技术,是近年来中国石油集团公司修井技术发展中的新亮点,是修井作业技术和工艺的一场革命。对于油水井而言常规压井不仅施工成本高、时间长,而且污染油层、堵塞油水通道,影响产量和注水效果;而采用放喷泄压,又破坏地层能量平衡、压力恢复时间长、地下注采单元内油井产量会受到影响,而且放喷排放含油污水还给环境污染带来重大隐患,也增加了罐车等的拉运费用和再次注水费用。带压作业无需放喷泄压,可有效的保护储层,它已是“稳定和提高单井日产量”的一项重要手段。新疆油田水井维修周期较长,井内无相应的井底开关阀,井内除垢和油管内堵塞技术是制约带压技术的关键环节;新疆油田公司根据自身井况研制了相应的堵塞工具,取得了不错的成绩;对于井内结构复杂,结垢严重的井提出新的思路和改进方法。 Workover with pressure well is a new bright spot in the development of workover technology of CNPC in recent years and is a revolution in workover techniques and techniques. For oil and water wells, the conventional well killing is not only costly and time-consuming to construct, but also pollutes the oil layer and blocks the passage of oil and water, affecting the yield and water injection effect. However, by releasing discharge pressure and destroying formation energy balance, the pressure recovery time is long, The production of oil wells in the unit will be affected, and discharge of oily wastewater by discharge will bring about significant risks to the environment pollution as well as increase of the transportation cost of the tanker and the re-injection of water. Pressure-relieving work without the need to relieve pressure and effectively protect the reservoir has been an important means of “stabilizing and increasing single-well daily output.” Xinjiang Oilfield wells maintenance cycle is longer, there is no corresponding hole bottom of the valve, well within the tube and plugging technology is the key to control the pressure with the technology; Xinjiang Oilfield Company developed a corresponding plug according to their well conditions, and achieved Good results; for well complex structure, serious scaling wells put forward new ideas and ways to improve.