论文部分内容阅读
An integrated low-phase-noise voltage-controlled oscillator(VCO) has been designed and fabricated in SMIC 0.18μm RF CMOS technology.The circuit employs an optimally designed LC resonator and a differential cross-coupling amplifier acts as a negative resistor to compensate the energy loss of the resonator.To extend the frequency tuning range,a three-bit binary-weighted switched capacitor array is used in the circuit.The testing result indicates that the VCO achieves a tuning range of 60%from 1.92 to 3.35 GHz.The phase noise of the VCO is -117.8 dBc/Hz at 1 MHz offset from the carrier frequency of 2.4 GHz.It draws 5.6 mA current from a 1.8 V supply.The VCO integrated circuit occupies a die area of 600×900μm~2.It can be used in the IEEE802.11 b based wireless local network receiver.
An integrated low-phase-noise voltage-controlled oscillator (VCO) has been designed and fabricated in SMIC 0.18 μm RF CMOS technology. The circuit an an optimally designed LC resonator and a differential cross-coupling amplifier acts as a negative resistor to compensate the energy loss of the resonator. extend the frequency tuning range, a three-bit binary-weighted switched capacitor array is used in the circuit. The testing result indicates that the VCO achieves a tuning range of 60% from 1.92 to 3.35 GHz. phase noise of the VCO is -117.8 dBc / Hz at 1 MHz offset from the carrier frequency of 2.4 GHz. It draws 5.6 mA current from a 1.8 V supply. The VCO integrated circuit occupies a die area of 600 × 900 μm ~ 2.It can be used in the IEEE802.11 b based wireless local network receiver.