【摘 要】
:
SiC whisker reinforced MoSi2 composite powder was synthesized by a novel process,referred to the literature as chemical oven self-propagating high temperature s
【机 构】
:
Institute of Material Surface Engineering,Shanghai Institute of Ceramics
论文部分内容阅读
SiC whisker reinforced MoSi2 composite powder was synthesized by a novel process,referred to the literature as chemical oven self-propagating high temperature synthesis(COSHS). The as-prepared SiCw/MoSi2 composite powder was rapidly sintered by spark plasma sintering(SPS) process. The sintering temperature and pressure were 1 723 K at heating rate of 100 K/min and 40 MPa,respectively. The microstructure and mechanical properties of the composite were investigated. Relative densities of the monolithic material and composite are 95% and 99.3%,respectively. SEM micrographs of SiCw/MoSi2 composite show that SiC whiskers homogeneously distribute in MoSi2 matrix. The composite containing SiC whisker has higher Vicker hardness than monolithic MoSi2. Especially the room-temperature fracture toughness of the composite is higher than that of MoSi2,from 3.6 MPa -m1/2 for MoSi2 to 7.7 MPa-m1/2 for composite with 15% SiC(volume fraction),increased by 113.9%. The morphology of propagation of crack and fractured surface of composite reveal the mechnaism to improve fracture toughness of MoSi2 matrix. The results show that the in-situ SiCw/MoSi2 composite powder prepared by COSHS technique can be successfully sinterded through SPS process and significant improvement of low temperature fracture toughness can be achieved.
其他文献
Age hardening characteristic and tensile property of Mg-3.5Dy-4.0Gd-3.1Nd-0.4Zr alloy were investigated. The alloy exhibits a considerable age hardening effect
In functionally graded materials (FGM), the problem of interface stability caused by the volume deformation is commonly regarded as the key factor for its perfo
The annealed microstructures of the rolled AZ31 alloy sheets were examined by using light optical microscopy. The mechanical properties were measured by tensile
The magnetization, magnetostriction and compressive strengths of arc-cast polycrystalline and directionally solidified Tb0.36Dy0.64(Fe1-xMnx)1.9 (x=0, 0.05, 0.1
Besides the two phase transitions known in ferroelectromagnets, an additional transition was observed experimentally in Pb(Fe1/2Nb1/2)O3 and the possible mechan
One kind of novel reactive thermotropic liquid crystalline polymer-methacryloyl copolymer (LCMC) containing polyester mesogenic units was synthesized. Its struc
Novel ordered mesoporous Eu(DBM)3phen/APTES-SBA-15 (EAS) composites with reasonable photoluminescence property and interesting morphology of bundles of pearl-li
The electromagnetic pump imposes the electromagnetic motive force (Lorentz force) on the liquid metal directly and makes it move along the definite direction by
Epoxy resin was modified by multi-walled carbon nanotubes (MWCNTs) with an in situ method. The composite was observed using scanning electron microscopy (SEM) a
A super absorbent material was prepared with the super absorbent resin ( SAR ) and inorganicgel.The SAR of the carboxymethyl cellulose grafting acrylic acid ( C