A novel indocyanine green-based fluorescent marker for guiding surgical tumor resection

来源 :JournalofInnovativeOpticalHealthSciences | 被引量 : 0次 | 上传用户:wanglq2009
下载到本地 , 更方便阅读
声明 : 本文档内容版权归属内容提供方 , 如果您对本文有版权争议 , 可与客服联系进行内容授权或下架
论文部分内容阅读
Surgical tumor resection is a common approach to cancer treatment. India Ink tattoos are widely used to aid tumor resection by localizing and mapping the tumor edge at the surface. However, India Ink tattoos are easily obscured during electrosurgical resection, and fade in intensity over time. In this work, a novel near-infrared (NIR) fluorescent marker is introduced as an alternative. The NIR marker was made by mixing indocyanine green (ICG), biocompatible cyanoacrylate, and acetone. The marking strategy was evaluated in a chronic ex vivo feasibility study using porcine tissues, followed by a chronic in vivo mouse study while compared with India Ink. In both studies, signal-to-noise (SNR) ratios and dimensions of the NIR markers and/or India Ink over the study period were calculated and reported. Electrocautery was performed on the last day of the mouse study after mice were euthanized, and SNR ratios and dimensions were quantified and compared. Biopsy was performed at all injection sites and slides were examined by a pathologist. The proposed NIR marker achieved (i) consistent visibility in the 26-day feasibility study and (ii) improved durability, visibility, and biocompatibility when compared to traditional India Ink over the six-week period in an in vivo mouse model. These e?ects persist after electrocautery whereas the India Ink markers were obscured. The use of a NIR fluorescent presurgical marking strategy has the potential for intraoperative tracking during long-term treatment protocols.
其他文献
We propose the single feeder fiber architecture for wavelength division multiplexing passive optical network (WDM-PON) based on directly modulated chirp managed laser (CML). The downlink (DL) signal output from the laser is converted to return-to-zero (RZ
期刊
用纯音声波代替相干光束“照明”物体,可获得声学全息照片,用激光照射时,这种声学全息照片就变为三维图象。
期刊
期刊
为了提高全息光栅曝光系统的曝光对比度,抑制外部环境变化引起的曝光干涉条纹漂移,提出了一种移栅型干涉条纹锁定方法。采用分束光栅实现光源激光的分光及干涉条纹的相位调整。通过叠栅条纹间接测量干涉条纹相位变化,给出了双光电探测器的最佳探测位置。结合分光及相位调整功能,给出了分束光栅参数的设计方法。针对光栅曝光特点设计了控制器。从理论上对比了分束光栅与压电反射镜的相位调整性能。实验结果表明,采样频率为500 Hz时,干涉条纹的低频漂移得到有效抑制,相位锁定精度达到0.13 rad (3σ),即条纹漂移量低于±0.0
研究了多纤芯弹性光网络中的选路以及纤芯分配问题。由于交换纤芯会影响网络性能,建立了一个以最小化阻塞率为目标的全局约束优化模型。考虑路径的长度以及路径的频谱可用性,为每一个业务请求选择候选路径集,设计了具有高效的编码方法、特制交叉、变异及局部搜索算子的遗传算法。在不同的网络拓扑中进行了仿真实验,实验结果表明,所提算法在相同情况下能够得到比对比算法更小的业务阻塞率。
基于微纳波导中的四波混频效应(FWM)可以实现相应的光逻辑功能,研究了在这类非线性波导中,信号噪声对四波混频效应的影响。针对通信系统中常见的高斯噪声,具体分析了在金属-介质-金属(MIM)结构的波导中,输入信号光分别受到幅度噪声、频率噪声、相位噪声以及加性噪声影响之后对四波混频效应的各种影响。结果表明,在相位噪声的平均功率增大到1.44以上时,基于四波混频所产生闲频光的归一化强度小于-40 dB,远低于无噪声时的-18 dB,非线性效率出现较大降低;而当信号光受其他噪声影响时,四波混频产生闲频光的强度与无
期刊
从全光函数的空-角耦合关系出发,分别从空间域、角度域、耦合域和投影域上提取视觉特征,并提出一种无参考光场质量评价方法。在空间域上提取中心子孔径图的自然场景统计(NSS)特征;在角度域和空-角耦合域上分别提取宏像素和极平面图(EPI)上的灰度共生矩阵(GLCM)特征;在投影域上提取重聚焦图局部熵统计分布特征。最后将多视觉特征融合,形成光场的视觉特征向量,使用支持向量回归(SVR)训练出评分模型,建立
提出了一种制作收集光信息视角范围大、光信息利用效率高、具有良好抗外界应力及温度变化能力的曲面微透镜阵列的新方法。采用光刻离子交换工艺,通过对镀钛掩膜、光刻和离子交换等关键工艺的研究和严格控制,在球面玻璃基片上制作了六角形孔径平面微透镜阵列。制作的阵列单元透镜六角形边长0.173 mm,窗口间距0.200 mm,单片阵列上微透镜元2052个。测试表明,离子交换深度0.198 mm,阵列填充率达到98%,阵列成像性能优良,光学均匀性好,旋转椭球状的单元透镜区域折射率呈三维梯度变化,截距、数值孔径自中心向边缘渐
利用偏振光互连,发展起一种积木式紧凑结构形态学处理器,它具有结构紧凑、体积小、抗环境干扰,易于维护使用及高包装密度等优点。同时也给出了该处理器的实验结果。