8.磁电机向发动机上安装的方法对C210型磁电机,首先拆下高压线,拧下火花塞。从火花塞孔口处插入一把清洁的尺子,顶在活塞顶部。按汽油机旋转方向转动飞轮,使活塞达上止点位置(即尺子被顶起的最高位置),在尺子对齐火花塞孔口处作一记号。然后以此记号为基准,向上量取5.8毫米再作一记号(图1)。反转 8. Magneto to the engine installation method C210-type magneto, first remove the high-voltage line, unscrew the spark plug. Insert a clean ruler from the plug hole on the top of the piston. Turn the flywheel in the direction of rotation of the gasoline engine so that the piston reaches the top dead center position (ie, the top position where the ruler is raised) and makes a mark at the orifice of the ruler aligned with the spark plug. Then use this mark as a reference, take the amount up 5.8 millimeters and make a mark (Figure 1). Reverse