Transparent armor consists of glass-polymer laminates in most cases.The formation and propagation of damage in the different glass layers has a strong influence on the ballistic resistance of such laminates.In order to clarify(he course of events during projectile penetration,an experimental technique was developed,which allows visualizing the onset and propagation of damage in each single layer of the laminate.A telecentric objective lens was used together with a microsecond video camera that allows recording 100 frames at a maximum rate of 1 MHz in a backlit photography set-up.With this technique,the damage evolution could be visualized in glass laminates consisting of four glass layers with lateral dimensions 500 mm x 500 mm.Damage evolution was recorded during penetration of 7.62 mm AP projectiles with tungsten carbide core and a total mass of 1 1.1 g in the impact velocity range from 800 to 880 m/s.In order to measure the deformation of single glass plates within the laminates,a piece of reflecting tape was attached to the corresponding glass plate,and photonic Doppler velocimetry(PDV) was applied.With the photonic Doppler velocimeter.an infrared laser is used to illuminate an object to be measured and the Doppler-shifted light is superimposed to a reference light beam at the detector.The simultaneous visualization and PDV measurement of the glass deformation allow determining the deformation at the time of the onset of fracture.The analysis of the experimental data was supported by numerical simulations,using the AUTODYN commercial hydro-code. Transparent armor consists of glass-polymer laminates in most cases. The formation and propagation of damage in the different glass layers has a strong influence on the ballistic resistance of such laminates. In order to clarify (he course of events during projectile penetration, an experimental technique was developed, which allows visualizing the onset and propagation of damage in each single layer of the laminate. A telecentric objective lens was used together with a microsecond video camera that allows recording 100 frames at a maximum rate of 1 MHz in a backlit photography set -up.With this technique, the damage evolution could be visualized in glass laminates consisting of four glass layers with lateral dimensions 500 mm x 500 mm. Damage evolution was recorded during penetration of 7.62 mm AP projectiles with tungsten carbide core and a total mass of 1 1.1 g in the impact velocity range from 800 to 880 m / s. Order to measure the deformation of single glass plates within the laminates, ap iece of reflecting tape was attached to the corresponding glass plate, and photonic Doppler velocimetry (PDV) was applied. With the photonic Doppler velocimeter. an infrared laser is used to illuminate an object to be measured and the Doppler-shifted light is superimposed to a reference light beam at the detector.The simultaneous visualization and PDV measurement of the glass deformation allow determining the deformation at the time of the onset of fracture. analysis of the experimental data was supported by numerical simulations, using the AUTODYN commercial hydro-code.