【摘 要】
：
The objective of this work is to study the synthesis of copper-alumina nanocomposites using the coprecipitation process and hot-pressing method, and investigate their mechanical properties. The effects of calcination temperature on the average size of com
【机 构】
：
College of Material Science & Technology, Nanjing University of Aeronautics & Astronautics, Nanjing
【出 处】
：
武汉理工大学学报（材料科学版）（英文版）
论文部分内容阅读
The objective of this work is to study the synthesis of copper-alumina nanocomposites using the coprecipitation process and hot-pressing method, and investigate their mechanical properties. The effects of calcination temperature on the average size of composite particles and chemical composition after calcination were also analyzed. The sintering parameters including sintering temperature, hot pressure and packing time were optimized to fabricate the alumina nanoparticles reinforced copper matrix composites (CMCs). The density, microhardness and tribological properties of the CMCs reinforced with 1 wt%, 2 wt%, 3 wt%, 4 wt% and 5 wt% of alumina nanoparticles were investigated correspondingly. The results showed that the optimum preparation parameters for the CMCs were 900℃ of hot pressing temperature, 27.5 MPa of hot pressure and 2 hrs of packing time. The CMC reinforced with 2 wt% of alumina nanoparticles had the lowest wear rate, with the relative wear resistance of 3.13.
其他文献
In order to analyze the microstructure of salt anti-freezing asphalt concrete, i e, MFL (Mafilon) modified asphalt concrete, MIP (mercury intrusion porosity) method was used to obtain the data including porosity and pore size distribution in micro scale.
The nature of the pull-out system of carbon nanorope/polyethylene (CNRP/PE) composite is studied by using molecular dynamics approach.The deformation of the CNRP/PE composites in pull-out process is exhibited.The influence of twisting deformation on the i
Spark plasma sintering (SPS) was used to weld the ceramics,eg, Cr3C2 and metal, Ni in this paper. It is found that the SPS can weld the Cr3C2 and Ni plates at lower temperatures and shorter holding time comparing with that of hot-pressing (HP). The bindin
Bi-doped MO-B2O3 (M=Ca, Sr, Ba) glasses were prepared by melting method. Excitation spectra, visible and infrared luminescence spectra were measured. Near infrared (NIR) emissions located at about 1190 nm with FWHM only 40 nm and at 1300 nm with FWHM abou
In order to research the field sensing characteristic of the carbon fiber smart material, the Tikhonov regularization principle and the modiifed Newton-Raphson(MNR) algorithm were adopted to solve the inverse problem of the electrical resistance tomograph
A sensitive and selective method for the determination of ascorbic acid (AA) using [Cu(phen)2]2+/multiwalled carbon nanotubes modified glassy carbon electrode was developed. Electrochemical behavior and surface characteristics of the modified electrode we
A micromechanical model based on discrete element method (DEM) was employed to investigate the effects of aggregate size and specimen scale on the cracking behavior of asphalt mixture. An algorithm for generating three-dimensional aggregates that can refl
Double-scale model for three-dimension-4 directional(3D-4d) braided C/SiC composites has been proposed to investigate its elastic properties. The double-scale model involves micro-scale that takesfi ber/matrix/porosity infi bers tows into consideration wi