【摘 要】
:
In order to lower the raw materials cost and develop a novel cathode materials for intermediate temperature solid oxide fuel cell(ITSOFC), using mixed rare eart
【机 构】
:
Institute of Materials and Technology,Department of Material Science and Engineering
论文部分内容阅读
In order to lower the raw materials cost and develop a novel cathode materials for intermediate temperature solid oxide fuel cell(ITSOFC), using mixed rare earth replacing the expensive pure La2O3 as the raw materials, the powders of Ln0.7Sr0.3-xCaxCo0.9Fe0.1O3-δ (Ln=the mixed rare earth, x=0.05, 0.10, 0.15) for the applications as the cathode materials were prepared by microwave sintering process. The crystal structure and the particles morphology of the obtained powders were characterized by XRD and SEM, the electrical conductivity of all samples sintered at 1200 ℃ for 3 h was also measured as the function of the temperature from 100 to 800 ℃ by DC four-probe method in air. The experimental results show that due to the influence of mixed rare earth the powders of Ln0.7Sr0.3-xCaxCo0.9Fe0.1O3-δ synthesized at 1200 ℃ for 0.5 h with the mean particle size of 1~20 μm was of perovskite and cubic fluorite phase as well a little SrO phase, the electrical conductivity of the samples decreases with the adding Ca2+ content, and are all higher than 100 S·cm-1 from 500 to 700 ℃ when x≤0.10. Ln0.7Sr0.3-xCaxCo0.9Fe0.1O3-δ. Can meet the demand of the electrical properties for the cathode materials in ITSOFC.
其他文献
A modified cellular automaton (MCA) model has been extended to the ternary alloy system by coupling thermodynamic and phase equilibrium calculation engine PanEn
H.264/MPEG-4 AVC standard appears highly competitive due to its high efficiency, flexibility and error resilience. In order to maintain universal multimedia acc
The corrosion behavior of WE54 magnesium alloy was investigated in 3.5%NaCl aqueous solution. The electrochemical study shows that the value of corrosion potent
The different aging process was investigated for ZK60 magnesium alloy to get the ideal synthetic properties. The results show that the values of strength, hardn
The phase stability and structural distortion of NiO under high pressure were investigated using first-principles calculations based on density-functional theor
Fine-grained magnesium alloys strengthened by quasicrystalline particles were easily developed by thermomechanical process for Mg-Zn-Y-Zr alloys. The microstruc
The high undercooling technique by molten glass slag purification and cyclical superheating in Ar atmosphere was applied to bulk Fe-B alloy melts. A hypercoolin
In order to veritably measure the first peak of hydration heat evolution that has been illustrated important in indicating cement behavior in early hydration, a
Anisotropic Nd-Fe-B magnets were fabricated by the single stage hot deformation (SSHD) method. The magnetic properties of the anisotropic Nd-Fe-B magnets are as
Y2O3 nanomaterials have been widely used in transparent ceramics and luminescent devices. Recently there are many studies focusing on controlling the size and m