The present work establishes an analytical model for computing the temperature distribution, fin efficiency and optimum design parameters of a constructal T-shaped porous fin operating in fully wet condition. For more practical results, this study considers a cubic polynomial relationship between the humidity ratio of saturated air and the corresponding fin surface temperature. The temperature distribution has been determined by solving the highly non-linear governing equations using a semi-analytical transformation technique called Differential Transform Method. A comparison of the results with that of a numerical model shows that this transformation method is a very efficient and convenient tool for solution of non-linear problems. The effects of various geometric, thermo-physical and psychometric parameters on the temperature distribution, fin efficiency and optimum design condition have been investigated. Also, a comparison has been presented between solid and porous fins and the results point out that by selecting an appropriate value of porosity, the heat transfer rate can be increased than the corresponding solid fin. The present work establishes an analytical model for computing the temperature distribution, fin efficiency and optimum design parameters of a constructal T-shaped porous fin operating in fully wet condition. For more practical results, this study considers a cubic polynomial relationship between the humidity ratio of The air distribution has been determined by solving the highly non-linear governing equations using a semi-analytical transformation technique called Differential Transform Method. A comparison of the results with that of a numerical model shows that this The methods of a variety of geometric, thermo-physical and psychometric parameters on the temperature distribution, fin efficiency and optimum design condition have been investigated. Also, a comparison has been presented between solid and porous fins and the r esults point out that by selecting an appropriate value of porosity, the heat transfer rate can be increased than the corresponding solid fin.