The technique of geotextile tubes used to construct dikes for land reclamation has been widely used. The tubes are usually filled with slurry of soil, such as sand, silt or clay. The tensile stress developed in the geotextile during filling the tube is the dominant factor for construction of a safe dike. The existing design methods are good for designing sausage shaped tubes and can not be directly applied for designing flat tubes, which are commonly used in dike construction. This paper presents a procedure that can determine the relationship among the tube size, the pumping pressure, the unit weight of the slurry, and the tensile stress developed in the geotextile during the tube filing. When the tubes are piling up to form the dike, the tubes in the bottom will sustain the load from the weight of the upper ones. A procedure is also developed to calculate the changes of the mechanical and geometrical behavior of the tubes under the load with a similar method. All these approaches have been programmed, which can help dike designers to select the suitable geotextile and determine the profile of the dike.