【摘 要】
：
The 7××× aluminum alloys having a microstructure with precipitate free zones (PFZ) nearby the grain boundary, have received a great deal of attention due to
【机 构】
：
School of Materials Science and Engineering
论文部分内容阅读
The 7××× aluminum alloys having a microstructure with precipitate free zones (PFZ) nearby the grain boundary, have received a great deal of attention due to their high strength, light mass, and yet poor fracture toughness. Experimental investigation into the effect of microstructure on the ductility was well established and comprehensive in the literature. A micromechanical model using a unit cell including some voids and relevant microstructural features was created. The competition between intergranular and intragranular fracture was investigated by comparing the void growth velocity between PFZ and matrix. The effects of void aspect ratio, relative PFZ volume, orientation of PFZ on the ductility of 7××× aluminum alloys were analyzed. The results show that the model can explain the effect of microstructure on the competition between intergranular and intragranular fracture.
其他文献
A 3-D simulation of grain growth was conducted by utilizing cellular automata (CA) and Monte Carlo (MC) algorithm. In the simulating procedure, the three-dimens
采用第一原理方法,基于ultrasoft赝势、密度函数理论,从原子层面对纯γ Mn的顺磁、铁磁和反铁磁性状态下的电子、基态属性、相稳定和磁有序结构进行了研究.通过自旋极化分析
The extrusion of Al-Si alloy powders with different particle sizes allows manufacture of different products with unique microstructures and therefore with uniqu
The MoSi2 coating on C103 niobium based alloy was prepared by pack cementation method. The formative mechanism,morphology and structure of coating were investig
The room-temperature oxygen plasma treatment before depositing ZnO films on nanocrystalline diamond substrates was studied. The nanocrystalline diamond substrat
The effect of Nb in (La0.5Ce0.5)64-xAl16Ni5Cu15Nbx (x=0-5, mole fraction) bulk metallic glasses was investigated by X-ray diffractometry, differential scanning
In order to evaluate the effect of stoichiometric ratio upon electrochemical properties of AB5-type hydrogen storage alloys, a series of alloys Mm0.8La0.2(Ni4.0
The deformation behavior of squeeze cast ZK60 magnesium alloy was investigated by compressive tests conducted at temperatures of 250-450 ℃ and strain rates of
The effects of reactive gas partial pressure on droplet formation,deposition rate and change of preferred orientation of CrN and Cr2O3 coatings were studied. Fo
Many factors were found to have effects on the conversion coatings for AZ31 alloy, alloy the most important one in producing high quality conversion coatings is