我廠在刨梳棉机另件斩刀片(如圖一)的齒時,以前是在牛头刨床上一个齒一个齒的刨,效率很低,刨時一排夾四十餘片,約四天才能刨完一排。因效率太低,影响其他工序加工,後來曾改用車床夾具在車床上車齒,但效率也不甚高,而車出的齒形易偏倒且带有螺旋角度,达不到要求。後來經过多次改进,成功了一套自動刨齒工具。这种方法可適用在各种類似的工件上,效率 I plant in the planing card Another piece of carding machine blade (Figure 1) of the teeth, the former is a shaper in a tooth a tooth planing, the efficiency is very low, a row when planing more than 40 tablets, about four days Can planing a row. Because of the low efficiency, affect the other processes, and later had switched to the lathe on the lathe, but the efficiency is not very high, but the car out of the tooth profile is easy to be partial and with a spiral angle, not up to requirements. After several improvements later, a set of automatic gear tooth tools were successfully implemented. This method can be applied to a variety of similar workpieces, efficiency