论文部分内容阅读
(1)床身与底座的装配程序 操作顺序: ①先用固定螺丝结合床身与底座六个固定螺丝。 ②打定位销两个。 ③打入主轴。 注意事项: ①在紧定螺丝时应同时把六个螺丝逐渐拧入。 ②在未结合以前,须把给合面用直尺校正一下,如发现有不平时加以修整。 ③定位销子的销孔必须对梢。 ④底
(1) Bed and base assembly procedures Operating sequence: ① first with a fixed screw combination of the bed and the base of the six setscrew. ② to locate the pin two. ③ into the spindle. Note: ① in the tight screws should be gradually screwed into the six screws at the same time. ② Before uncombined, must be given to the surface with a ruler to correct it, if there is uneven to be trimmed. ③ pin positioning pin hole must tip. ④ the end