【摘 要】
：
In this work,a 2D covalent triazine-based framework was prepared by using 1,3-dicyanobenzo[c]thiophene (DCBT) as monomer to effectively capture CO2.The resulting CTF-DCBT was characterized by FVIR,XPS,PXRD,elemental analysis,SEM,TEM,and N2 adsorption-deso
【机 构】
：
State Key Laboratory of Organic-Inorganic Composites, Beijing University of Chemical Technology, Bei
论文部分内容阅读
In this work,a 2D covalent triazine-based framework was prepared by using 1,3-dicyanobenzo[c]thiophene (DCBT) as monomer to effectively capture CO2.The resulting CTF-DCBT was characterized by FVIR,XPS,PXRD,elemental analysis,SEM,TEM,and N2 adsorption-desorption.The results indicate that CTF-DCBT is partially crystalline and has ultramicropore (6.5 A) as well as high heteroatom contents (11.24wt％ and 12.61wt％ for N and S,respectively).In addition,the BET surface area and total pore volume of CTF-DCBT are 500m2/g and 0.26cm3/g,respectively.CTF-DCBT possesses excellent thermal stability (450 ℃) and chemical stability towards boiling water,4 M HCl,and 1 M NaOH,The CO2 adsorption capacity of CTF-DCBT is 37.8 cm3/g at 1 bar and 25 ℃.After six adsorption-desorption cycles,there is no obvious loss of CO2 uptake observed.Due to the ultramicropore and high heteroatom contents,CTF-DCBT has high isosteric heats of adsorption for CO2 and high selectivities of CO2 over N2 and CH4.At 25 ℃,the CO2/N2 and CO2/CH4 selectivities are 112.5 and 10.3,respectively,which are higher than those of most POFs.Breakthrough curves indicate that CTF-DCBT could effectively separate CO2/N2 and CO2/CH4 mixtures.
其他文献
Two novel hole transport materials (HTMs) with indaceno[1,2-b:5,6-b\']dithiophene (IDT) as core building blocks,termed IDT1 and IDT2,were designed and synthesized.The side alkyl chains were introduced to regulate and control the morphology and stacking
Recently,binary metal oxides have been considerably researched for energy storage since it can provide higher electrical conductivity and electrochemical activity than single components.Besides,rational arrays structure design can effectively enhance the
Applications of in-situ and ex-situ spectroscopic ellipsometry (SE) are presented for the development of parametric expressions that define the real and imaginary parts (ε1,ε2) of the complex dielectric function spectra of thin film solar cell components.
Lead halide perovskites have some unique properties which are very promising for optoelectronic applications such as solar cells,LEDs and lasers.One important and expected application of perovskite halide semiconductors is solar cell operation including h
Herein we report a systematical investigation on the promoting effect of the carbon chain length of the intercalated carboxylic anions on the CO2 capture performance of Mg-Al layer double hydroxides (LDHs).A series of organo-LDHs were successfully synthes
NS codoped carbon nanorods (NS-CNRs) were prepared using crab shell as template and polyphenylene sulfide (PPS) as both the C and S precursor,followed by carbonization in NH3.The as-obtained NS-CNRs had a diameter of ～50 nm,length of several micrometers,a
A novel fibrous silica Y zeolite (HSi@Y) loaded with Pt has been studied based on its ability to produce protonic acid sites originating from molecular hydrogen.The Pt/HSi@Y was prepared using seed assisted crystallization followed by protonation and Pt-l
Cobalt carbide (Co2C) was considered as potential catalysts available for large-scale industrialization of transforming syngas (H2 and CO) to clean fuels.Herein,we successfully synthesized Co-based catalysts with MnO supported,to comprehend the effects of
Copper (Ⅱ) oxide in varying ratios was combined with either an alumina-based cement (A1300),or CaO derived from limestone as support material in a mechanical pelletiser.This production method was used to investigate its influence on possible mechanical an
Na metal anode,benefiting from its high theoretical capacity and lowest electrochemical potential,is one of the most favorable candidates for future Na-based batteries with high energy density.Dendrite growth,volume change and high reactivity are the form