【机 构】
：
KeyLaboratoryofMaterialsforHighPowerLaser,ShanghaiInstituteofOpticsandFineMechanics,ChineseAcademyof
论文部分内容阅读
The combination of deep wet etching and a magneto-rheological finishing (MRF) process is investigated to simultaneously improve laser damage resistance of a fused-silica surface at 355 nm. The subsequently deposited SiO2 coatings are researched to clarify the impact of substrate finishing technology on the coatings. It is revealed that a deep removal proceeding from the single side or double side had a significant impact on the laser-induced damage threshold (LIDT) of the fused silica, especially for the rear surface. After the deep etching, the MRF process that followed does not actually increase the LIDT, but it does ameliorate the surface qualities without additional LIDT degradation. The combination guarantee both the integrity of the surface’s finish and the laser damage resistance of the fused silica and subsequent SiO2 coatings.
其他文献
We propose a radio frequency (RF) transfer technique with passive phase noise compensation over a fiber-optic ring. By adopting different frequencies and same wavelength transmission and double sideband (DSB) with carrier suppression (DSBCS) modulation, t
太赫兹目标散射特性的测量是太赫兹成像等研究领域的一个重要环节。在测量中，为了获得高准直度的宽光束和减少能量损耗，需引入离轴抛物面镜。但离轴抛物面镜的引入会带来装调困难。利用光学设计软件Zemax，分别分析了光学系统中的准直系统和收集系统，通过对三个离轴抛物面镜的倾斜角和偏心距的分析，得出了在118.83 μm的太赫兹发射源中，系统可允许的离轴抛面镜最大装调误差。
日本研究人员利用光学物理手段已经设计了一种传输真空紫外辐射的柔性光纤。在某些波长处，有些材料的折射率低于1，该组利用这种材料制作真空紫外光纤的包层，而以空内部作为波导。
为实现苹果可溶性固形物(SSC)的便携式快速检测, 利用环形光纤探头和微型光谱仪搭建便携式苹果可溶性固形物光谱采集系统, 结合无信息变量消除(UVE)、 遗传算法(GA)、 竞争性自适应加权(CARS)算法筛选基于偏最小二乘(PLS)的苹果可溶性固形物的近红外光谱特征波长。 另外, 采用反向区间最小二乘支持向量机(BiLS-SVM)和GA算法优选基于LS-SVM的特征波长变量, 分别建立所选特征波长和全波段的PLS模型和LS-SVM模型。 试验结果表明, 经过GA-CARS算法从全波段1 512个波长中筛
In this paper, the peak-to-average power ratio (PAPR) of orthogonal frequency division multiplexing (OFDM) signal is reduced by combining the discrete cosine transform (DCT) with clipping in optical intensity-modulated direct-detection (IM/DD) OFDM system
本文报道使用空心阴极与较普通的放电技术的连续锌离子激光器的噪声谱的研究情况。从目前的工作中发现，与以前设计的用于锌离子激光器的放电管相比，这种空心阴极的工作方式有两个非常显著的优点：第一，输出光束的噪声水平极低；其次是从离子的高能级跃迁时，单位长度上的增益有明显的提高。
Based on the principle that a rectangular function can be expanded into a sum of complex Gaussian functions with finite numbers, propagation characteristics of a Gaussian beam or a plane wave passing through apertured fractional Fourier transforming syste
针对水体小角度范围内后向散射强度测量难的问题,基于沙氏成像原理设计了水体沙氏激光雷达系统。介绍了水体沙氏激光雷达系统的设计、模拟及搭建,并对去离子水、自来水及河水三种水体进行水槽实验。详细介绍了多测量介质条件下的距离校正方法。将后向散射的光束宽度和强度变化情况与分光光度计测量数据进行比较,发现激光光束的宽度及强度变化表征光束衰减情况,同时可表征不同水体的后向散射强弱规律。分光光度计数据与水体沙氏激光雷达数据结果具有较好的一致性。
In this Letter, we propose two crosstalk-aware routing, core, and spectrum assignment (CA-RCSA) algorithms for spatial division multiplexing enabled elastic optical networks (SDM-EONs) with multi-core fibers. First, the RCSA problem is modeled, and then a