AS—I总线在火电厂翻车机系统的应用

来源 :起重运输机械 | 被引量 : 0次 | 上传用户:yulihui2638685
下载到本地 , 更方便阅读
声明 : 本文档内容版权归属内容提供方 , 如果您对本文有版权争议 , 可与客服联系进行内容授权或下架
论文部分内容阅读
论述AS—interface总线技术在火电厂翻车机系统中应用的可行性,利用该总线技术可解决实际工作中大量采用连接电缆,故障点多,电磁干扰难以排除,工程维修量大等弊端。
其他文献
In this paper,we propose an equal interval range approximation and expandinglearning rule for multi-layer perceptrons applied in pattern recognitions.Compared w
Two k-hyperconnection expressions of a general k-order cofactor Y<sub>(i,j)</sub> are presentedfor the indefinite parameter matrix Y of a linear system by applyin
A definition of combined phase center for horn feeds is given.Formulas of E-planeand H-plane combined phase center for conical horns and the corresponding Optim
Recognition of modulation system is an important problem in the modern electronicreconnaissance.A general method for solving this problem is suggested in this p
归纳总结了影响拣货路径的各种因素,并以低层固定货架仓库为例,重点研究了各种订单拣货路径策略及路径长度确定方法,在对实际应用较多的启发式方法进行比较分析基础上,根据路
The microstructure and optical properties of a buried layer formed by O<sup>+</sup>(200keV,1.8&#215;10<sup>18</sup>/cm<sup>2</sup>)and N<sup>+</sup>(180 keV,4&#
Binary code signals have been widely used in various radars due to their simpleimplementation,but the selection of the binary codes with high comporession ratio
An inverse design of electrostatic focusing field for electrostatic and magneticimaging is investigated.Using the potential superimposition theorem of electrost
四辊铜带轧机是一种体积庞大、结构复杂、安装精度高的大型机组。轧机机架安装精度直接影响其加工精度,以此特别要对机架安装精度进行控制。
A new iterative method for signal, restoration has been presented. An estimateoperator W_κ which is related to error operator B_κ in the restoration process i