CBN砂轮的整形和修整较为困难,这在很大程度上妨碍了CBN砂轮的推广应用。树脂结合剂CBN砂轮一般在整形后都需经过修整,以使CBN磨粒充分凸出。悬浮磨料法是一种比较好的修整方法,很容易在外圆磨床上实现,而在平面磨床上,由于没有另外的动力头,实现起来就要困难得多。按一般设想则需在磨床工作台上安放一个电机以驱动钢轮,在钢轮和CBN砂轮的间隙中投放混油磨料以达到修整的目的。但这样的装置就较为复杂,并且由于磨头的空间位置限制,使得钢轮没有合适的安放位置。为此,对在平 CBN grinding wheel shaping and dressing more difficult, which largely hindered the CBN wheel of the promotion and application. Resin bond CBN wheel generally after shaping needs to be trimmed to make CBN abrasive particles fully protruding. Suspended abrasive method is a good dressing method, it is easy to achieve cylindrical grinder, and in surface grinder, because there is no other power head, it is much more difficult to achieve. As a general idea, you need to place a motor on the grinding machine table to drive the drum, put the mixed abrasive in the gap between the drum and the CBN wheel to achieve the purpose of dressing. However, such a device is relatively complicated, and the steel wheel does not have a suitable seating position due to the restriction of the spatial position of the grinding head. To this end, right