【摘 要】
：
Twin-roll thin strip casting process combines casting and hot rolling into a single process,in which thermal stress and thermal mechanical stress were involved.
【机 构】
：
Department of Material Science and Engineering,Research Center of High Technology
论文部分内容阅读
Twin-roll thin strip casting process combines casting and hot rolling into a single process,in which thermal stress and thermal mechanical stress were involved. Considering the high temperature gradient,the existing of liquid and solid regions and rolling deformation,suitable constitutive model is the key to describe the process. Anands model is a temperature-dependent,rate-dependent and unified of creep and plasticity model and the Jaumann derivative was employed in Anands model which makes the constitutive model frame-indifferent or objective,therefore the highly nonlinearities behavior in the twin-roll casting process can be simulated. The parameters of the Anands model were regressed based on the compression tests of AZ31 magnesium alloy. The simulation results reveal that the Anands model can well describe the deformation characteristics of twin-roll casting process. Based on the simulation results,the form of evolution equations in Anands model was discussed.
其他文献
The influences of preparation conditions of Al-5Ti-B (as-cast and hot-rolled) and Al-10Sr (as-cast and hotextruded) and melt treatment procedures on the grain r
A model considering quantitative effects of diffused carbon and nitrogen gradients and kinetics of phase transformation is presented to examine metallo-thermo-m
The microstructural evolution of cold-rolled aluminum alloy 3003 during annealing was investigated by means of micro-hardness measurement, electrical resistivit
A series of new microwave dielectric ceramics Ba3-nLa1+nTinNb3-nO12 (n=0,1,2) were prepared in the BaO-La2O3-TiO2-Nb2O5 system by high temperature solid-state r
The microstructures of the AZ91D die-cast magnesium alloy were investigated by scanning electron microscopy (SEM), X-ray diffractometry (XRD) and energy dispers
Based on the heat transfer theory and liquid solidification theory, the heat transfer during the rapid solidification process of amorphous ribbons prepared by m
The vesicant problem during the process of preparing closed-cell aluminum foam by molten body transitional foaming process was discussed and the effect of granu
A stable δ- and β-bismuth trioxide was prepared at room temperature by vacuum vapor-phase oxidation. The average crystal size of products was 14.6 nm (by XRD)
SiCp/Gr/2024Al metal matrix composites were processed by squeeze casting technology. The microstructure of composites was observed by SEM and TEM, and the effec
This research indicates that the gradient of internal relative humidity (IRH) decreases rapidly within 7-day curing age in HPC.The amount of water imported by p