论文部分内容阅读
我们在修复中间轴二档齿时,采用以下两种不同的工艺:一、加工好二档齿环后再镶焊1.将损坏的中间轴按图1的要求进行加工。由于二档齿环是从一档齿的一端套入,所以将一档齿的外圆也车削去3毫米,经在城市客车行驶实践证明,很少用一档起步,另外,被车掉的又是一档齿的齿尖,因此仍不损一档齿的使用寿命。
We are in the middle of the second gear repair gear, the use of the following two different processes: First, the second gear after processing the second set of gear ring welding 1. The damaged intermediate shaft according to the requirements of Figure 1 for processing. Since the second gear ring is engaged from one end of the first gear, the outer gear of the first gear is also cut to 3 mm. It has been proved by practice in city buses that seldom starts off in a stall. In addition, Also a gear tooth tip, it still does not damage the service life of a gear.