在使用固体渗碳剂进行渗碳操作的过程中,我们发现了渗碳剂的效能与使用方法对渗碳层的厚度有很大关系。将用后的渗碳剂在干燥的地方堆放保存,和将用后的渗碳剂倾出后,立即喷洒4～5 %的水摊开来保存,在再次使用时其效能差别很大。在相同的条件下渗碳所得的渗碳层深度不同。就渗碳层深度为1毫米的工件来看,就相差0.2～0.3毫米,也就是用倾出后喷水的渗剂碳时,所得的渗层厚度此未经喷水处理的渗碳剂效果高。 In the process of using carburizing carburizing for carburizing, we found that carburizing efficiency and using method have a great influence on the thickness of carburized layer. After use of the carburizing agent in a dry place piled up preservation, and the use of carburizing agent after pouring, immediately spray 4-5% of the water spread to save, in the re-use of its performance vary widely. Under the same conditions carburizing obtained carburized layer depth. The carburizing depth of 1 mm of the workpiece point of view, a difference of 0.2 to 0.3 mm, that is, after pouring out of water after the penetration of the agent carbon, the resulting thickness of the infiltration of this untreated carburizing effect high.