负载型ZnO/SiO2及ZnO-SiO2溶胶凝胶催化剂的表面结构研究

来源 :高等学校化学学报 | 被引量 : 0次 | 上传用户:thskaoyan
下载到本地 , 更方便阅读
声明 : 本文档内容版权归属内容提供方 , 如果您对本文有版权争议 , 可与客服联系进行内容授权或下架
论文部分内容阅读
ZnO/SiO-2 and ZnO|SiO-2 catalysts were prepared by the impregnation and sol|gel method, respectively. The characterization of the catalysts by XPS and FTIR indicated that much “free” zinc oxide and unreacted Si_OH existed on the surface of ZnO/SiO-2 sample. As for ZnO|SiO-2 sol|gel catalyst, the corresponding phenomena were not observed. The prepared samples were also used as the catalysts for decomposition of 2|butanol. A high selectivity for dehydrogenation was observed over the supported catalyst. However, a high selectivity for dehydration was shown over the ZnO|SiO-2 sol|gel catalyst. The opposite selectivity for dehydration or dehydrogenation observed over the two kinds of catalysts may be just because of the different surface structures of the catalysts. ZnO / SiO - 2 and ZnO | SiO - 2 catalysts were prepared by the impregnation and sol | gel method, respectively. The characterization of the catalysts by XPS and FTIR indicated that much “free ” As for ZnO | SiO - 2 sol | gel catalyst, the corresponding phenomena were not observed. The prepared samples was also used as the catalysts for decomposition of 2 | butanol. A high selectivity for dehydrogenation was observed over the supported catalyst. However, a high selectivity for dehydration was shown over the ZnO | SiO - 2 sol gel catalyst. The opposite selectivity for dehydration or dehydrogenation observed over the two kinds of catalysts may be just because of the different surface structures of the catalysts.
其他文献
研究了K3C6 0 单晶薄膜在 2 0 0K附近的导带结构 .样品温度为 190K时 ,同步辐射角分辨光电子谱能够观察到[111]方向有规律的能带色散 .而在 2 2 0K附近色散不存在 .这一实验
根据电子碰撞机制类氖氩毛细管放电机理,在一台最大输出电压300 kV的Marx发生器基础上设计了一套完整的毛细管放电装置.对该装置进行了系统调试,在充氩气10 cm长毛细管负载下
以Nd(NO3)3@6H2O和NH2C6H4COOH为原料,经[Nd(C7N6O2)3@H2O]的自组装,得到了具有三维网络结构的配位聚合物[Nd(C7H6NO2)3@H2O]n.该聚合物晶体属单斜晶系,空间群P2(1)/n,a=0.98
为了解决电化学发光电池LECs离子传导聚合物与发光聚合物两相分离的问题,采用Wittig反应,合成了一种分子主链上带有刚性共轭发光链段--二(二甲氧基取代苯乙烯)萘与柔性离子传
以Ba0.95Ce0.9Y0.1O3-α为固体电解质,Pt为电极,组成氢-空气燃料电池,测定了该电池600~1000℃下电流-电压特性、电极极化特性和电解质中各电荷载流子(质子、氧离子、电子空穴)
The unique characteristics of gas-solids two-phase flow and fluidization in terms of the flow structures and the apparent behavior of particles and fluid-partic
红外光探针是扫描近场红外显微镜 (SNIM)中的关键部件 ,由于探针的种类和材料不同 ,制作的方法也不同 .一般制作光纤探针有两种方法 ,即热拉伸法和化学腐蚀法 .这里叙述了一
对不同结构的超导故障限流器(SFCL)在实用化过程中所面临的一些技术关键问题,如动作电流整定、参数选择、失超恢复问题及对继电保护的影响,进行了比较研究。研究表明,高温超导带
评述了近年来原子力显微镜和扫描隧道显微镜应用于脱氧核糖核酸研究领域的样品制备过程.主要内容涉及基底的选择与处理、样品的固定与展开方法、优缺点以及改进过程.
生物体利用生物矿化作用,在有机分子模板上协同合成有种间差异的生物SiO2材料.具有精确形态可控的固态SiO2结构是在蛋白和多糖生物分子诱导下,在水相、中性pH和室温等温和反