Copper foils with gradient structure in thickness direction and different roughnesses on two surfaces were fabricated by double rolling.The two surface morphologies of double-rolled copper foils are quite different,and the surface roughness values are 61 and 1095 nm,respectively.The roughness value of matt surface can meet the requirement for bonding the resin matrix with copper foils used for flexible printed circuit boards,thus may omit traditional roughening treatment; the microstructure of double-rolled copper foils demonstrates an obviously asymmetric gradient feature.From bright surface to matt surface in thickness direction,the average grain size first increases from 2.3 to 7.4 μm and then decreases to 3.6 μm; compared with conventional rolled copper foils,the double-rolled copper foils exhibit a remarkably increased bending fatigue life,and the increased range is about 16.2%. Copper foils with gradient structure in thickness direction and different roughnesses on two surfaces were fabricated by double rolling. Two surface morphologies of double-rolled copper foils are quite different, and the surface roughness values ​​are 61 and 1095 nm, respectively. of matt surface can meet the requirement for bonding the resin matrix with copper foils used for flexible printed circuit boards, thus may omit traditional roughening treatment; the microstructure of double-rolled copper foils demonstrates an obvious asymmetric gradient feature. From bright surface to matt surface in thickness direction, the average grain size first increases from 2.3 to 7.4 μm and then decreases to 3.6 μm; compared with conventional rolled copper foils, the double-rolled copper foils exhibit a remarkably increased bending fatigue life, and the increased range is about 16.2 %.