Far Infrared Radiation Property of Rare Earth Mineral Composite Materials

来源 :稀土学报(英文版) | 被引量 : 0次 | 上传用户:windplume
下载到本地 , 更方便阅读
声明 : 本文档内容版权归属内容提供方 , 如果您对本文有版权争议 , 可与客服联系进行内容授权或下架
论文部分内容阅读
Rare earth mineral composite materials were prepared using rare earths and natural far-infrared mineral materials. The influences of rare earth additive content and heat treatment temperature on the far infrared radiance were studied. The results show that the far infrared radiance of rare earth mineral composite materials is 0.93 when the rare earth additive content is 6% and heat treatment temperature is 750 ℃.
其他文献
Twin roll casting method is a promising route to directly produce magnesium alloy strip. It is a rapid solidification process with high temperature gradient com
First-principles calculations on neutral metal impurities (Mg,Zn and Ca) in zinc blende GaN were studied. Formation energies were calculated for substitution on
The deterioration mechanism of thaumasite towards cement or concrete structure and the deterioration pattern of in-situ construction caused by the formation of
The present investigation focuses on the parametric influence of machining parameters on the surface finish obtained in turning of glass fiber reinforced polyme
Bioreduction as a novel nanoparticle synthesizing technology attracts increasing attention. Dried cells of the bacterium Aeromonas sp. SH10 rapidly reduced [Ag(
The thermal stability, phase transformation, surface morphology, pore size distribution and permeation of the defect-free silica-zirconia membrane were investig
A rapid method for the determination of impurity elements, such as Zn, Ni, Co, Cr, Cu, Cd and Pb in manganese tetroxide was developed, using inductively coupled
The nickel electroplating process was investigated by means of electrochemical noise(EN), cyclic voltammetry in conjunction with the scanning electron microscop
V2O5 nanotube arrays in porous anodic alumina ( PAA ) template were obtained from V2 O5sols prepared by melt quenching method.X-ray powder diffraction and selec
Plasma carburization at two different methane-to-argon gas ratios (5:5 and 6:5) was carried out on the cast TiAl based alloy of Ti-46.5Al-2.5V-1Cr (mole fractio