Frequency stabilization of pulsed CO2 laser using setup-time method

来源 :ChineseOpticsLetters | 被引量 : 0次 | 上传用户:UserReg
下载到本地 , 更方便阅读
声明 : 本文档内容版权归属内容提供方 , 如果您对本文有版权争议 , 可与客服联系进行内容授权或下架
论文部分内容阅读
A new method for laser-frequency stabilization by controlling the pulse setup time is presented. The frequency-stabilization system monitors the pulse setup time continuously, and controls it by adjusting the cavity length. Laser frequency is stabilized to the center of the gain curve when the setup time is the shortest. The system is used to stabilize a radio-frequency-excited waveguide CO2 laser tuned by grating, and the shift of laser frequency is estimated to be less than §25 MHz for an extended period. The system has the advantages of compact structure, small volume, and low cost. It can be applied for frequency stabilization of other kinds of pulsed lasers with adjustable cavity.
其他文献
A stable and uniform multi-wavelength fiber laser based on the hybrid gain of a dispersion compensating fiber as the Raman gain medium and an erbium-doped fiber (EDF) is introduced. The gain competition effects in the fiber Raman amplification (FRA) and E
This Letter presents intrinsic Fabry–Perot interferometers in the fiber tapers fabricated by the femtosecond laser micromachining technique. The sensing of temperatures as high as 1000°C based on the fiber device is characterized, with a sensitivity of
在数字图像处理领域中,尺度不变特征变换(SIFT)算法是特征点识别的代表性算法。以开放运算语言(OpenCL)并行计算为加速手段,建立了基于改进的SIFT算法的双目测距系统,深入研究了如何加快SIFT算法的运算速度。在加快SIFT算法方面,选取了积分均值模糊,并利用OpenCL对其进行并行加速,对算法进行并行优化后,使之能够在NVIDIA GPU硬件平台上进行实现。在获取精确视差方面,对原SIFT
演示了一种基于大模面积掺Yb3 离子的全光纤放大器系统, 该系统采用975 nm泵浦。系统是利用泵浦与Yb3 离子有源光纤相互作用产生信号源, 光源为半导体激光放大的单频种子。通过优化系统, 合理设计搭建光学器件, 控制光束逆传输, 减少非线性光学的干扰。100 W信号源作用于系统上, 采用多级掺镱光放大的主振荡器功率放大器(MOPA), 最大输出3.2 kW连续激光。平均光-光转化效率为78.26%。光束质量Mx2≈1.657, My2≈1.735。输出稳定性小于2%。系统连续信号放大输出光具有广泛的应
在传统的单点校正和两点校正的基础上,提出了一种新的可适应不充分场景变化条件的端口间动态场景自适应修正算法。该算法基于动态场景成像过程中多端口图像数据之间的相关性,使用FPGA+ARM硬件平台,采用实时修正偏置系数的方式,实现多端口图像实时非均匀性校正,解决了定标算法无法根据环境进行自适应调整和场景算法不能进行实时校正的问题。
We have proposed and demonstrated a double-pass ytterbium-doped fiber amplifier using an optical circulator and a fiber Bragg grating as reflector. When the signal has passed through the ytterbium-doped fiber once, it reflects off a 0.2-nm passive fiber B
Three-dimensional (3D) electrically conductive micro/nanostructures are now a key component in a broad range of research and industry fields. In this work, a novel method is developed to realize metallic 3D micro/nanostructures with silver-thiol-acrylate
研制了一种用于体内成像诊断和光动力学治疗的荧光显微内窥术,可根据探测的荧光信号强度,采用反馈算法快速调节不同成像区域的激发光强度,获取高信噪比、大动态范围的荧光图像, 实现交互式荧光诊断与光动力学治疗分析。根据反馈的治疗效果,自适应地连续实时调整光剂量,获得最佳的光动力学治疗结果。激发光强度的动态调整由计算机控制数字微镜器件的开关状态及驻留时间来实现。荧光显微内窥镜的外径尺寸为8 mm,工作长度为250.3 mm,可装配在腹腔镜管鞘中,适用于体内病灶的显微成像诊断。实验结果表明,显微成像视场为600 μ
期刊