Influence of blasting on the properties of weak intercalation of a layered rock slope

来源 :矿物冶金与材料学报 | 被引量 : 0次 | 上传用户:jlq520
下载到本地 , 更方便阅读
声明 : 本文档内容版权归属内容提供方 , 如果您对本文有版权争议 , 可与客服联系进行内容授权或下架
论文部分内容阅读
A precondition for correctly analyzing the stability of a slope and designing its bracing structure is to study and determine the influence of excavation blasting on the properties of weak intercalation in the layered rock slope.On the basis ofin-situ stratifica-tion-cracking blasting tests,the properties of weak intercalation were investigated using the LS-DYNA3D program.The displace-ment distribution and compactness of weak intercalation at different positions away from the charge center and their various laws are discussed.The critical displacement of stratification-cracking (0.1 mm) was obtained,and an approximate expression of compactness were deduced.Furthermore,through the simulation of a layered rock blasting under the same geological conditions,the stratifica-tion-cracking effect of deep-hole blasting on the properties of weak intercalation was compared with that of short-hole blasting,and the influencing differences,in addition to their causes,were analyzed.The results indicated that the blasting cavity of weak intercala-tion in short-hole blasting with a radius of 40 mm was nearly a circle,whose radius was about 28.7 cm;whereas in deep-hole blasting with a radius of 150 mm,the shape of the blasting cavity was different from that in short-hole blasting,the radius of the cavity be-hind the charge (89.1 cm) was further smaller than those of the other three (138.7 cm),and there were sharp crinkles on the surface of weak intercalation.When the distance from the charge center (DCC) was less than 40 and 150 cm in short-hole and deep-hole blast-ing,respectively,the displacement of weak intercalation was reduced remarkably with the increase in DCC.
其他文献
文章对船舶运动极短期预报技术进行了探讨和评价。论述了极短期运动预报的定义,从不同角度对极短期预报方法进行了分类。并对极短期预报方法的发展进行了叙述及讨论,分析了这些
A two-dimensional model was established in the rectangular co-ordinate to study the thermal stress in the sapphire single crystal grown by the improved Kyropoul
Effect of the deformed microstructure on mechanical properties of an orthorhombic (Ti2AlNb) based alloy of Ti-22Al-25Nb (mole fraction, %) has been investigated
Mold filling in lately-developed Thixomolding(R) process is a complex process, of which numerical simulation is necessary for development. Governing equations a
The research was conducted to evaluate the effects of cellulose and polyester fibers on the properties of porous asphalt mixes,using the tests of draindown,abra
The toughness of 31Mn2SiRE wear-resistance cast steel were increased by means of RE compound modification and high temperature austenitizing. The results show t
For the maintenance of the pipelines which pipe oil from oil fields in the Bohai Gulf of China, an underwater vehicle for pipeline detection and maintenance (PD
The deformation-induced textures in electrodeposited nickel coating were numerically studied. The finite element method (FEM) for polycrystalline was developed
A pure aluminum matrix composite reinforced by Bi2O3-coated aluminum borate whisker was fabricated by a squeeze casting method. The mass ratio of Bi2O3 to whisk
A novel method to measure the temperature on the surface of micro-hotplate was presented. The tiny fiber probe and the optical power meter were employed to meas