我厂生产的釜用减速机按使用要求应达到滴油不漏,结果用户使用后反应有漏油现象。经查找原因发现,密封在装配过程中由于装配不当而损坏了密封唇口,导致减速机漏油,后改进密封装配手段,解决了漏油现象,密封装配过程如下: 剪一张大小适中,厚度小于0.5mm的纸垫。卷成纸筒5套在轴6上;装有密封4的密封盒3顺着纸筒5套在轴6上,直至密封盒3止口挂上箱体2的孔中,拧紧螺栓7,取下纸筒(5),这样密封4在装配中不被轴6上的台阶损坏密封4的唇口。 通过以上改进后,不但解决了漏油现象,而且还提 I plant the kettle with the reducer according to the requirements should be reached without dripping oil, the results of the user reaction after the oil spill. After finding the reasons, the seal found in the assembly process due to improper assembly damage to the sealing lip, resulting in reducer leakage, improved seal assembly means to solve the oil leakage, seal the assembly process is as follows: Cut a medium-sized, the thickness Paper pad less than 0.5mm. Rolled into a paper tube 5 set on the shaft 6; seal 4 with a sealed box 3 along the paper tube 5 set on the shaft 6, until the seal box 3 hanging mouth hanging box 2, tighten the bolt 7 (5) so that the seal 4 is not damaged in the assembly by the step on the shaft 6 from damaging the lip of the seal 4. Through the above improvements, not only solved the oil spill, but also mentioned