【摘 要】
：
Graphene-sulfur (G-S) hybrid materials with sulfur nanocrystals anchored on interconnected fibrous graphene are obtained by a facile one pot strategy using a sulfur/carbon disulfide/alcohol mixed solu
【机 构】
：
Shenyang National Laboratory for Materials Science,Institute of Metal Research,Chinese Academy of Sc
论文部分内容阅读
Graphene-sulfur (G-S) hybrid materials with sulfur nanocrystals anchored on interconnected fibrous graphene are obtained by a facile one pot strategy using a sulfur/carbon disulfide/alcohol mixed solution.The reduction of graphene oxide and the formation/binding of sulfur nanocrystals were integrated.
其他文献
分析频率响应法的扫频范围的选择对电力变压器绕组故障的检测影响,确定检测变压器绕组故障的最佳扫频范围.针对目前的频率响应法大部分都是离线测量,响应速度一般,脉冲频率响应法是解决上述问题的一个途径.脉冲频率响应法中激励信号和响应信号在时域中实现,频率响应曲线的获取大都采用快速傅里叶变换(FFT)进行转换,但此方法只适用于处理平稳信号,对暂态信号进行时频转换容易造成频谱泄露.短时傅里叶变换(STFT)是
气体绝缘金属封闭式组合电器(GIS)的现场冲击耐压试验能够更加有效地检测出金属尖刺、绝缘子断裂等制造、运输与装配过程中出现的集中性缺陷，已成为设备现场耐压试验的重要组成部分。本文针对1000kV 淮南-南京-上海交流特高压南京变电站1100kV GIS 现场雷电冲击耐压试验工程，利用ATP-EMTP 电磁暂态分析软件对特高压GIS 现场冲击耐压试验系统进行建模，并研究了特高压GIS 现场冲击耐压试
传感器是局部放电特高频检测中的关键技术。本文概述了特高频检测技术在GIS 绝缘状态监测中的应用现状，对内置式传感器的阻抗带宽、有效高度和最小可测放电量三个指标进行了说明和讨论，分析了相互间的联系。目前GIS 内置传感器类型主要有五种，分别是盘形天线、环形天线、偶极子天线、平面螺旋天线和锥形天线。对其分别进行了综述和评价，并总结了提高传感器检测性能和增加传感器可靠性与安全性的方法。最后就当前该领域内
随着电力系统电压等级的不断提高,GIS 外壳过电压(TEV)对变电站工作人员与设备的威胁将越来越大,为了准确的进行TEV 测量,研制了一套基于差分探头的TEV 测量系统.首先对传统的TEV 测量设备Newi 探头进行原理及缺陷分析,并在其基础上设计了差分探头测量系统,包括进行高、低压臂均压套筒设计,高压臂电阻选择与差分接线方式设计.设计的差分探头TEV 测量系统阶跃响应电压上升时间约为3 ns,部
Nanostructured Fe3O4 is one of most commonly used active materials in the Li-ion battery,due to its high theoretical capacity (928mAhg-1)[1,2]and good electronic conductivity (2×104 Sm-1)[3].However,t
A new type of platelet-like ammonium vanadium bronze (NH4)2V6O16 is first used as cathode material for Na-ion battery.The discharge capacity and cycling stability is improved by the intercalation of t
A novel sulfur infiltration method via two-step of vacuum-vapor/melting adsorption was used to prepare high-rate performance sulfur-carbon composite cathodes.The hierarchical activated carbon (HAC) wi
The increasingly prominent energy and environment problems accelerate the rapid development of the lithium ion batteries.LiNi0.5Mn1.5O4 (LNMO) possessing a specific capacity of about 140 mA h g-1 and
In this paper,a very simple solution method is employed to coat amorphous MnO2 onto crystalline V2O5 nanoparticles grown on stainless steel substrate,which utilizes the better electrochemical performa
磷酸钒锂(Li3V2(PO4)3,LVP)是继磷酸铁锂之后的另一极具市场应用潜力的聚阴离子型正极材料.Li3V2(PO4)3具有斜方(NASCION)和单斜两种晶型.斜方晶系的电化学性能较差,不适合用作锂离子电池正极材料;而单斜结构Li3V2(PO4)3的热力学性质非常稳定,在锂离子电池中作为电极材料具有很大的潜力[1].