【摘 要】
：
Organic-inorganic hybrid perovskite solar cells have undergone an unprecedented development as the next-generation photovoltaic devices in recent years.The power conversion efficiency and stability ar
【机 构】
：
College of Physics,Optoelectronics and Energy,Jiangsu Key Laboratory of Thin Films,Center for Energy
论文部分内容阅读
Organic-inorganic hybrid perovskite solar cells have undergone an unprecedented development as the next-generation photovoltaic devices in recent years.The power conversion efficiency and stability are the key factors attracting great attentions from both academic and industrial communities.Here we insert a nonoxide CdS layer between TiO2 and perovskite to passivate the TiO2 interface in planar-type perovskite solar cells.After introducing the CdS layer,we observe significantly enhanced air stability and suppressed recombination between the trapped electrons and perovskite related with inverse transport.At the optimum CdS thickness,a champion power conversion efficiency of 14.26%is achieved compared with 10.31%for the reference CdS-free devices.This impressive efficiency also surpasses that of previously reported perovskite solar cells based on CdS.The largely improved performance is ascribed to the increased Fermi level of electron transport layer,more efficient charge transport and lower recombination rates.
其他文献
通过简单的溶剂热法制备了CoNi2S4纳米粒子,其最大比电容为1636.2F g-1.为了研究其实际应用价值,将CoNi2S4纳米粒子作为正极,活性炭作为负极,成功组装了液相不对称超级电容器.该不对称超级电容器在3mol L-1的KOH溶液中电压窗口能达到0-1.6V,其最大能量密度能达到53.1Wh Kg-1,即使在功率密度为7630W Kg-1时,能量密度也能达到36.7Wh Kg-1.而且,
A low-cost,highly active,stable,and methanol tolerant electrocatalyst towards the oxygen reduction reaction(ORR)is extremely desirable for promoting the commercialization of fuel cells.Herein,we repor
Solid-state thermoelectric technology,interconverting heat to electrical energy,offers a promising solution for relaxing global energy problems.A high dimensionless figure of merit ZT is desirable for
Organic-inorganic hybrid perovskites have attracted extensive interest in recent years due to their remarkable properties in highly efficient solar cells.The quality of the perovskite thin films has b
由于电动汽车在实际运行中,总是处于不同工况下,且工况差别较大,锂电池表现出了极大的非线性,传统方法很难准确预测电池的荷电状态(Stateof Charge,SOC),所以只能采用特定的数学方法进行估算.本文提出了一种基于BP神经网络的电池SOC预测方法.该方法首先是以特定的放电倍率对锂电池进行了放电实验,获取其电过程中电压、电流和SOC的样本数据,然后用实验所得的样本数据训练BP神经网络,根据训练
本文根据燃料电池在线性电位扫描下的响应特征,建立了等效电路模型,以区分电池内部的电化学过程,包括氢脱附,双电层电容充电,电子内部短路以及氢气渗透.基于此模型,改进了线性电位扫描的分析方法,消除了扫描速率对结果的影响,并解析得到了氢气渗透电流和电子电阻.根据模型假设,详细阐述了恒电流扫描测量气渗透电流和电子电阻的分析方法.在一个34cm2的单体电池上应用两种方法进行测量对比,结果表明:线性电位扫描得
本文首先采用修正的Hummers法制备氧化石墨,通过超声振荡得到在水中稳定GO分散液,在不加任何还原剂和分散剂的条件下制备Au/GO分散液,并将其制备成乳液;接着在氮气保护的条件下,采用乳液聚合法制备了Au/GO稳定的聚苯乙烯(PS)微球;最后以对硝基苯酚的还原反应为例对其催化活性进行了研究.结果表明,聚苯乙烯能够成功制备出来,并且Au/GO-PS聚合材料能够表现出更高的催化活性.
本文主要以氧化石墨烯为分散剂的Pickering乳液的制备及其影响因素研究.首先通过修正的Hummers法制备氧化石墨烯,通过超声波清洗器的超声振荡得到在水中稳定分散的GO.采用红外,拉曼,扫描电镜等测试分析了GO的官能团和元素及其结构.结果表明GO可以作为稳定Pickering乳液的乳化剂,再通过对比实验对Pickering乳液的影响因素进行研究.主要研究了温度、超声时间、乳化剂浓度对乳液稳定性
石墨烯可以作为理想的电极修饰材料。本论文采用Hummers法制备出氧化石墨(GO),用L-半胱氨酸对其进行还原,制得石墨烯(GN).随后制备出了金属氧化物/石墨烯复合材料NiO/GN、MnO2/GN、ZnO/GN和Co3O4/GN.利用红外(FT-IR)、X射线衍射(XRD)、拉曼(Raman)、扫描电镜(SEM)、热重(TG)等技术对样品的结构、形貌及热稳定性进行研究.采用循环伏安法(CV)研究
本文采用反应等离子沉积方法分别制备了锡掺杂的氧化铟(ITO)和钨掺杂的氧化铟(IWO)薄膜,并研究氧气与氩气的比例(Ro)对ITO和IWO薄膜光电性能的影响.通过优化工艺,制备了透过率超过95％的ITO薄膜和迁移率超过80cm2/V.s的IWO薄膜.虽然IWO的电导率和透过率均比ITO差,但由于其低的自由载流子寄生吸收,基于IWO的SHJ太阳电池光电转化效率超过22％,比基于ITO的SHJ太阳电池