Effect of dispersion on indistinguishability between single-photon wave-packets

来源 :PhotonicsResearch | 被引量 : 0次 | 上传用户:djnm080910
下载到本地 , 更方便阅读
声明 : 本文档内容版权归属内容提供方 , 如果您对本文有版权争议 , 可与客服联系进行内容授权或下架
论文部分内容阅读
With propagating through a dispersive medium, the temporal–spectral profile of optical pulses should be inevitably modified. Although such dispersion effect has been well studied in classical optics, its effect on a single-photon wave-packet has not yet been entirely revealed. In this paper, we investigate the effect of dispersion on indistinguishability between single-photon wave-packets through the Hong–Ou–Mandel (HOM) interference. By dispersively manipulating two weak coherent single-photon wave-packets which are prepared by attenuating mode-locked laser pulses before interfering with each other, we observe that the difference of the second-order dispersion between two optical paths of the HOM interferometer can be mapped to the interference curve, indicating that (i) with the same amount of dispersion effect in both paths, the HOM interference curve must be only determined by the intrinsic indistinguishability between the wave-packets, i.e., dispersion cancellation due to the indistinguishability between Feynman paths; and (ii) unbalanced dispersion effect in two paths cannot be canceled and will broaden the interference curve thus providing a way to measure the second-order dispersion coefficient. Our results suggest a more comprehensive understanding of the single-photon wave-packet and pave ways to explore further applications of the HOM interference.
其他文献
期刊
叠层扫描成像和傅里叶叠层扫描成像可增大视场和提高分辨率。基于多距离/多高度轴向扫描和薄柱透镜旋转扫描的计算成像技术采用相位恢复算法,可以高精度重建目标的复数光场。这些成像技术在扩大视场和提高分辨率方面具有显著优势。介绍了含变参数的光学相干衍射系统在计算成像方面的研究进展。作为间接成像形式,多参数成像技术是一类将衍射成像与算法相结合的计算成像技术,实现了复值光场的精确多维表征。
采用WP4-光学多道分析仪对准分子激光轰击Y_1Ba_2Cu_3O_x超导靶产生的等离子体辐射进行了空间分辨测量和研究。实验结果表明,在靶面的邻近区(d
搭建了基于近红外连续激光器的高灵敏度快速扫描光腔衰荡光谱仪(SC-CRDS)。通过压电陶瓷(PZT)快速扫描腔长,并用跟踪电路使腔长自动跟踪激光波长变化,实现衰荡光谱的快速测量。利用CH4在1653.73 nm(6046.95 cm-1)附近的光谱吸收峰,用该装置对CH4气体含量进行测量。通过测量多个光谱点确定吸收线中心吸收峰值和激光波长,并反馈补偿激光中心波长使其稳定在吸收线,成功解决了由于激光
为实现光学元件表面疵病的三维全场测量,提出了一种数字全息显微扫描成像的检测方法。该方法基于数字全息角谱数值重建算法,获得光学元件表面划痕的相位分布,通过扫描拼接实现划痕的全场测量;然后,在数字全息显微实验装置的基础上增加二维精密扫描部件,对于宽50μm、深50 nm标准划痕,测得其宽度为49.2μm、深度为48.9 nm,同时拼接获得该划痕的全场三维形貌。实验表明:该检测方法可实现大视场划痕缺陷的
介绍了基于InGaAs单光子探测器的日光条件测距实验,通过压缩激光接收视场、使用超窄带滤光片、结合超快主动淬灭电路等降低InGaAs单光子探测器死时间的方法,成功地进行了基于InGaAs单光子探测器的日光条件光子计数测距实验。分析实验数据,分别获取基于InGaAs探测器和Si基探测器的系统探测灵敏度、系统测距精度等参数,并进行比较。实验结果表明:经过高速主动淬灭电路优化后的InGaAs探测器,其死时间与Si基探测器的死时间相当;在背景光噪声一定的情况下,使用InGaAs探测器可以提高系统的探测灵敏度,从而
Infrared thermography determines the surface temperature of an object or human body. It is a promising imaging technology for medical and biological observations due to its contactless and completely noninvasive properties. However, traditional two-dimens
标准化是微流控系统的发展趋势, 很多器件需要精确的流量控制和传输。因此, 准确地表征和测量芯片功能模块的流体阻力具有重要的应用价值。提出了一种类比于惠斯通电桥测量不同流阻大小的器件, 该器件将一个芯片内的膜阀视为可变流阻器, 与待测器件并联。通过施加不同的压力, 控制膜阀的开口度, 保持桥平衡, 直接计算获得待测芯片的流阻大小。仿真计算发现, 其测量范围达到4个数量级, 误差控制在3%以内。结果表明, 微流控惠斯通电桥是测量流阻的有效方法, 可以根据不同的应用环境, 设计不同的尺寸和结构, 以满足特定需要
根据米氏理论,分别计算了由纯水、纯冰和冰水同心球形粒子构成的平面平行、各向同性云层的单次散射特性(单次散射反照率、不对称因子以及单次散射相矩阵)。根据辐射传输理论,利用累加法求解了矢量辐射传输方程,得到了3种不同构成云层的多次散射矩阵,对不同波长的太阳光的反射特性进行了比较。结果表明,反射光的偏振度比强度对云层的微观构成更敏感,并给出了理论解析。
期刊