3.2.7前乘员座侧侧面安全气囊电路检查(1)检查前乘员座侧侧面安全气囊导线是否短路。断开点火开关,脱开前乘员座侧座位总成2芯连接器,然后接通点火开关,观察诊断测试仪上显示的“前乘员座侧侧面安全气囊点火器电路”电阻,应大于6Q。否则说明 SRS 控制单元导线侧连接器端子13和端子14间的导线存在短路故障,或 SRS 控制单元损坏。(2)检查前乘员座侧侧面安全气囊导线是否断路。断开点火开 3.2.7 Front Passenger Seat Side Airbag Circuit Check (1) Check if the passenger’s seat side side airbag cable is short-circuited. Disconnect the ignition switch and disengage the front passenger seat side seat assembly 2-pin connector and turn on the ignition switch. Observe that the “front passenger side seat airbag igniter circuit” resistance shown on the diagnostic tester should be greater than 6Q. Otherwise, there is a short circuit in the wires between terminal 13 and terminal 14 on the wire side of the SRS control unit, or the SRS control unit is damaged. (2) Check whether the passenger’s seat side side airbag cable is open. Turn off the ignition