传统的线材剪切模,很难保证制件剪切面的垂直度和整洁度。这是因为它不能提供必要的支承,防止线材在被切断过程中过早地产生弯曲。使切断下来的制件两端,往往还要增加一道工序进行修整。为此,特推荐下述模具(图1)供你使用。该模具的特点是在切断模块下面增设了弹簧支承装置,这对克服上述缺点极为有效。 The traditional wire shear mode, it is difficult to ensure the verticality and cleanness of the workpiece shear surface. This is because it does not provide the necessary support to prevent premature bending of the wire during severing. To cut off the ends of the workpiece, often with an additional process to repair. To this end, especially recommended the following mold (Figure 1) for your use. The mold is characterized by the addition of spring support device below the cutting module, which is extremely effective to overcome the above shortcomings.