我厂最近完成的一项机械非标任务中,有一箱体,因盲孔的设置不合理造成了工艺性很差。现介绍如下: 附图箱体中有三个轴孔,轴I、轴Ⅱ用于齿轮传动,轴Ⅱ供变速齿轮的轴齿条滑动。其中轴Ⅰ的A端与凸缘安装的电动机刚性连接,轴Ⅱ和轴Ⅲ的A端均为盲孔。图中位置公差有“×”者为原设计标注,无“×”者为改进后的标注。从图中可知,由于盲孔和位置公差的限制,箱体 I plant a recently completed a mechanical non-standard tasks, there is a box, due to the blind hole set unreasonable caused by poor technology. Now introduced as follows: Figure box has three shaft holes, shaft I, shaft II for gear transmission, shaft II for gear shaft gear rack sliding. Wherein the A axis of shaft I is rigidly connected with the flange-mounted motor, and the A terminal of shaft II and shaft III are both blind holes. In the figure, position tolerance “×” is the original design label, no “×” is the improved label. Can be seen from the figure, due to the limitations of blind holes and position tolerances, box