【摘 要】
：
Chemical conversion treatment by rare earth metal salt solution was considered as an alternative to chromium chemical conversion treatment to improve the corros
【机 构】
：
College of Chemistry and Chemical Engineering, College of Materials Science and Engineering
论文部分内容阅读
Chemical conversion treatment by rare earth metal salt solution was considered as an alternative to chromium chemical conversion treatment to improve the corrosion resistance of magnesium alloys. In this study, cerium conversion coatings formed on AZ31 magnesium alloy were characterized and the formation mechanism was discussed. X-ray photoelectron spectroscopy (XPS) analysis showed that cerium conversion coating consisted of cerium hydroxides/oxides, in which both tetravalent cerium Ce(IV) and trivalent cerium Ce(III) species co-existed. Cerium conversion coating was a two-layer structure. Atomic force microscopy (AFM) images revealed that the morphology of the inside layer was different from that of the outside one, which was responsible for the inherent adhesive weakness of the coating. Corrosion potential (Ecorr) measurements indicated that poor adhesion limited the improvement of the corrosion resistance of the coating. During the treating process, the increased pH value of the cerium salt solution led to the precipitation of cerium hydroxides/oxides. The formation kinetics of the coating followed a parabolic curve.
其他文献
The microstructures of Ti6A14V alloy after hydrogenation were investigated by optical microscopy (OM), X-ray diffraction (XRD) and transmission electron microsc
A new ultrasonic three-point bending fatigue test device was introduced to investigate fatigue life ranging up to 1010 cycles and associated fracture behavior o
CFRP(carbon fiber reinforced plastics)composite materials have wide applicability because of their inherent design flexibility and improved material properties.
Recently,demand for the lightweight alloy in electric/electronic housings has been greatly increased.However, among the lightweight alloys,aluminum alloy thin-w
2×(FeNi/CoZnO)/ZnO/(CoZnO/Co)×2 spin-inJection devices were prepared by sputtering and photo-lithography. In the devices, two composite magnetic layers 2×(Fe
Taguchi approach was applied to determine the most influential control factors which will yield better tensile strength of the joints of friction stir welded RD
In this work,alpha(α)brass was poured in green sand mould and metallic chill mould at about 1050℃. Sand casting method and metallic chill casting method are r
The bioleaching behavior of low-grade copper sulphides under the condition of preferential solution flow was investigated through experiments.The experiment of
Multiple-metal catalysts (Ni-Mn-Ce-K/bauxite) for Water-Gas Shift (WGS) reaction were prepared by impregnation, and the catalytic structure and properties were
During the splitting spinning process,the material parameters of disk blank have a significant effect on the determination of forming parameters and the quality